Re: [PATCH 2/2] arm64: dts: rockchip: Enable SPI1 on Ficus

[Heiko Stuebner]

Am Montag, 6. Mai 2019, 14:04:58 CEST schrieb Manivannan Sadhasivam:
> Enable SPI1 exposed on both Low and High speed expansion connectors
> of Ficus. SPI1 has 3 different chip selects wired as below:
> 
> CS0 - Serial Flash (unpopulated)
> CS1 - Low Speed expansion
> CS2 - High Speed expansion
> 
> Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/rockchip/rk3399-ficus.dts | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/rockchip/rk3399-ficus.dts b/arch/arm64/boot/dts/rockchip/rk3399-ficus.dts
> index 027d428917b8..9baa378fc770 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3399-ficus.dts
> +++ b/arch/arm64/boot/dts/rockchip/rk3399-ficus.dts
> @@ -146,6 +146,12 @@
>  	};
>  };
>  
> +&spi1 {
> +	/* On both Low speed and High speed expansion */
> +	cs-gpios = <0>, <&gpio4 6 0>, <&gpio4 7 0>;

cs0 should still be part of the cs-gpios though (gpio1 RK_PB2).
The flash is part of the schematics, so there might be board with
it pre-populated or people might put a flash chip on it.

Also please use the constants for pin specification (RK_PA6, RK_PA7 above)


Heiko

> +	status = "okay";
> +};
> +
>  &usbdrd_dwc3_0 {
>  	dr_mode = "host";
>  };
>