[PATCH] spi: rockchip: turn down tx dma bursts

[Emil Renner Berthing]

This fixes tx and bi-directional dma transfers on rk3399-gru-kevin.

It seems the SPI fifo must have room for 2 bursts when the dma_tx_req
signal is generated or it might skip some words. This in turn makes
the rx dma channel never complete for bi-directional transfers.

Fix it by setting tx burst length to fifo_len / 4 and the dma
watermark to fifo_len / 2.

However the rk3399 TRM says (sic):
"DMAC support incrementing-address burst and fixed-address burst. But in
the case of access SPI and UART at byte or halfword size, DMAC only
support fixed-address burst and the address must be aligned to word."

So this relies on fifo_len being a multiple of 16 such that the
burst length (= fifo_len / 4) is a multiple of 4 and the addresses
will be word-aligned.

Fixes: dcfc861d24ec ("spi: rockchip: adjust dma watermark and burstlen")
Signed-off-by: Emil Renner Berthing <kernel@xxxxxxxx>
Signed-off-by: Mark Brown <broonie@xxxxxxxxxx>
---
 drivers/spi/spi-rockchip.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/spi-rockchip.c b/drivers/spi/spi-rockchip.c
index 3912526ead66..19f6a76f1c07 100644
--- a/drivers/spi/spi-rockchip.c
+++ b/drivers/spi/spi-rockchip.c
@@ -425,7 +425,7 @@ static int rockchip_spi_prepare_dma(struct rockchip_spi *rs,
 			.direction = DMA_MEM_TO_DEV,
 			.dst_addr = rs->dma_addr_tx,
 			.dst_addr_width = rs->n_bytes,
-			.dst_maxburst = rs->fifo_len / 2,
+			.dst_maxburst = rs->fifo_len / 4,
 		};
 
 		dmaengine_slave_config(master->dma_tx, &txconf);
@@ -526,7 +526,7 @@ static void rockchip_spi_config(struct rockchip_spi *rs,
 	else
 		writel_relaxed(rs->fifo_len / 2 - 1, rs->regs + ROCKCHIP_SPI_RXFTLR);
 
-	writel_relaxed(rs->fifo_len / 2 - 1, rs->regs + ROCKCHIP_SPI_DMATDLR);
+	writel_relaxed(rs->fifo_len / 2, rs->regs + ROCKCHIP_SPI_DMATDLR);
 	writel_relaxed(0, rs->regs + ROCKCHIP_SPI_DMARDLR);
 	writel_relaxed(dmacr, rs->regs + ROCKCHIP_SPI_DMACR);
 
-- 
2.20.1