Re: [PATCH] m68k: io: Fix io{read,write}{16,32}be() for Coldfire peripherals

[Angelo Dureghello]

Hi,

On Mon, Apr 29, 2019 at 02:39:47PM +0200, Arnd Bergmann wrote:
> On Mon, Apr 29, 2019 at 10:19 AM Geert Uytterhoeven
> <geert@xxxxxxxxxxxxxx> wrote:
> >
> > The generic definitions of mmio_{read,write}{16,32}be() in lib/iomap.c
> > assume that the {read,write}[wl]() I/O accessors always use little
> > endian accesses, and swap the result.
> >
> > However, the Coldfire versions of the {read,write}[wl]() I/O accessors are
> > special, in that they use native big endian instead of little endian for
> > accesses to the on-SoC peripheral block, thus violating the assumption.
> >
> > Fix this by providing our own variants, using the raw accessors,
> > reinstating the old behavior.  This is fine on m68k, as no special
> > barriers are needed, and also avoids swapping data twice.
> >
> > Reported-by: Angelo Dureghello <angelo@xxxxxxxx>
> > Fixes: aecc787c06f4300f ("iomap: Use non-raw io functions for io{read|write}XXbe")
> > Signed-off-by: Geert Uytterhoeven <geert@xxxxxxxxxxxxxx>
> > ---
> > This can be reverted later, after this oddity of the Coldfire I/O
> > support has been fixed, and drivers have been updated.
> > ---
> >  arch/m68k/include/asm/io.h | 6 ++++++
> >  1 file changed, 6 insertions(+)
> >
> > diff --git a/arch/m68k/include/asm/io.h b/arch/m68k/include/asm/io.h
> > index aabe6420ead2a599..d47e7384681ab1cd 100644
> > --- a/arch/m68k/include/asm/io.h
> > +++ b/arch/m68k/include/asm/io.h
> > @@ -8,6 +8,12 @@
> >  #include <asm/io_mm.h>
> >  #endif
> >
> > +#define mmio_read16be(addr)            __raw_readw(addr)
> > +#define mmio_read32be(addr)            __raw_readl(addr)
> > +
> > +#define mmio_write16be(val, port)      __raw_writew((val), (port))
> > +#define mmio_write32be(val, port)      __raw_writel((val), (port))
> > +
> >  #include <asm-generic/io.h>
> 
> This looks correct to me, but there are two points that stick out to me:
> 
> - why do you only do this for mmio and not for pio?
> - why do you even use the generic_iomap wrappers rather than
>   the trivial asm-generic versions of those functions?
> 
>        Arnd

At least i applied it and it works properly, dspi / dma drivers are
back working.

Thanks, 

Regards
Angelo