[PATCH v5 2/6] dt-bindings: usb: add binding for Type-B GPIO connector driver

[Chunfeng Yun]

It's used to support dual role switch via GPIO when use Type-B
receptacle, typically the USB ID pin is connected to an input
GPIO pin

Signed-off-by: Chunfeng Yun <chunfeng.yun@xxxxxxxxxxxx>
---
v5 changes:
 1. treat type-B connector as child device of USB controller's, but not
    as a separate virtual device, suggested by Rob
 2. put connector's port node under connector node, suggested by Rob

v4 no changes

v3 changes:
 1. treat type-B connector as a virtual device, but not child device of
    USB controller's

v2 changes:
  1. new patch to make binding clear suggested by Hans
---
 .../bindings/usb/typeb-conn-gpio.txt          | 42 +++++++++++++++++++
 1 file changed, 42 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt

diff --git a/Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt b/Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt
new file mode 100644
index 000000000000..20dd3499a348
--- /dev/null
+++ b/Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt
@@ -0,0 +1,42 @@
+USB Type-B GPIO Connector
+
+This is used to switch dual role mode from the USB ID pin connected to
+an input GPIO pin.
+
+Required properties:
+- compatible : should include "linux,typeb-conn-gpio" and "usb-b-connector".
+- id-gpios, vbus-gpios : either one of them must be present, and both
+	can be present as well.
+- vbus-supply : can be present if needed when supports dual role mode or
+	host mode.
+	see connector/usb-connector.txt
+
+Sub-nodes:
+- port : should be present.
+	see graph.txt
+
+Example:
+
+&mtu3 {
+	status = "okay";
+
+	connector {
+		compatible = "linux,typeb-conn-gpio", "usb-b-connector";
+		label = "micro-USB";
+		type = "micro";
+		id-gpios = <&pio 12 GPIO_ACTIVE_HIGH>;
+		vbus-supply = <&usb_p0_vbus>;
+
+		port {
+			bconn_ep: endpoint@0 {
+				remote-endpoint = <&usb_role_sw>;
+			};
+		};
+	};
+
+	port {
+		usb_role_sw: endpoint@0 {
+			remote-endpoint = <&bconn_ep>;
+		};
+	};
+};
-- 
2.21.0