[PATCH v13 0/2] add uart DMA function

[Long Cheng]

In Mediatek SOCs, the uart can support DMA function.
Base on DMA engine formwork, we add the DMA code to support uart. And put the code under drivers/dma/mediatek.

This series contains document bindings, Kconfig to control the function enable or not,
device tree including interrupt and dma device node, the code of UART DMA

Changes compared to v12
-rename parameters
-remove direction
Changes compared to v11
-modify TX/RX
-pause function by software
Changes compared to v10
-modify DMA tx status function
-modify 8250_mtk for DMA rx
-add notes to binding Document.
Changes compared to v9
-rename dt-bindings file
-remove direction from device_config
-simplified code
Changes compared to v8
-revise missing items
Changes compared to v7:
-modify apdma uart tx
Changes compared to v6:
-Correct spelling
Changes compared to v5:
-move 'requst irqs' to alloc channel
-remove tasklet.
Changes compared to v4:
-modify Kconfig depends on.
Changes compared to v3:
-fix CONFIG_PM, will cause build fail
Changes compared to v2:
-remove unimportant parameters
-instead of cookie, use APIs of virtual channel.
-use of_dma_xlate_by_chan_id.
Changes compared to v1:
-mian revised file, 8250_mtk_dma.c
--parameters renamed for standard
--remove atomic operation

Long Cheng (2):
  arm: dts: mt2712: add uart APDMA to device tree
  serial: 8250-mtk: modify uart DMA rx

 arch/arm64/boot/dts/mediatek/mt2712e.dtsi |   51 +++++++++++++++++++++++++++++
 drivers/tty/serial/8250/8250_mtk.c        |   49 +++++++++++----------------
 2 files changed, 71 insertions(+), 29 deletions(-)

-- 
1.7.9.5