[PATCH v2] firmware: ti_sci: Always request response from firmware
From: Andrew F. Davis
Date: Tue May 28 2019 - 11:58:40 EST
TI-SCI firmware will only respond to messages when the
TI_SCI_FLAG_REQ_ACK_ON_PROCESSED flag is set. Most messages already do
this, set this for the ones that do not.
This will be enforced in future firmware that better match the TI-SCI
specifications, this patch will not break users of existing firmware.
Fixes: aa276781a64a ("firmware: Add basic support for TI System Control Interface (TI-SCI) protocol")
Signed-off-by: Andrew F. Davis <afd@xxxxxx>
Acked-by: Nishanth Menon <nm@xxxxxx>
Tested-by: Alejandro Hernandez <ajhernandez@xxxxxx>
---
Changes from v1:
- Rebased on v5.2-rc2
drivers/firmware/ti_sci.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/firmware/ti_sci.c b/drivers/firmware/ti_sci.c
index ef93406ace1b..36ce11a67235 100644
--- a/drivers/firmware/ti_sci.c
+++ b/drivers/firmware/ti_sci.c
@@ -466,9 +466,9 @@ static int ti_sci_cmd_get_revision(struct ti_sci_info *info)
struct ti_sci_xfer *xfer;
int ret;
- /* No need to setup flags since it is expected to respond */
xfer = ti_sci_get_one_xfer(info, TI_SCI_MSG_VERSION,
- 0x0, sizeof(struct ti_sci_msg_hdr),
+ TI_SCI_FLAG_REQ_ACK_ON_PROCESSED,
+ sizeof(struct ti_sci_msg_hdr),
sizeof(*rev_info));
if (IS_ERR(xfer)) {
ret = PTR_ERR(xfer);
@@ -596,9 +596,9 @@ static int ti_sci_get_device_state(const struct ti_sci_handle *handle,
info = handle_to_ti_sci_info(handle);
dev = info->dev;
- /* Response is expected, so need of any flags */
xfer = ti_sci_get_one_xfer(info, TI_SCI_MSG_GET_DEVICE_STATE,
- 0, sizeof(*req), sizeof(*resp));
+ TI_SCI_FLAG_REQ_ACK_ON_PROCESSED,
+ sizeof(*req), sizeof(*resp));
if (IS_ERR(xfer)) {
ret = PTR_ERR(xfer);
dev_err(dev, "Message alloc failed(%d)\n", ret);
--
2.17.1