Re: [PATCH RESEND] ARM: dts: qcom: msm8974-hammerhead: add device tree bindings for vibrator

[Brian Masney]

On Wed, May 29, 2019 at 11:13:15AM +0200, Linus Walleij wrote:
> On Mon, May 20, 2019 at 4:21 PM Stephen Boyd <sboyd@xxxxxxxxxx> wrote:
> 
> > > +       vibrator@fd8c3450 {
> > > +               compatible = "qcom,msm8974-vibrator";
> > > +               reg = <0xfd8c3450 0x400>;
> >
> > This is inside the multimedia clk controller. The resource reservation
> > mechanism should be complaining loudly here. Is the driver writing
> > directly into clk controller registers to adjust a duty cycle of the
> > camera's general purpose clk?
> >
> > Can you add support for duty cycle to the qcom clk driver's RCGs and
> > then write a generic clk duty cycle vibrator driver that adjusts the
> > duty cycle of the clk? That would be better than reaching into the clk
> > controller registers to do this.
> 
> There is something ontological about this.
> 
> A clock with variable duty cycle, isn't that by definition a PWM?
> I don't suppose it is normal for qcom clocks to be able to control
> their duty cycle, but rather default to 50/50 as we could expect?
> 
> I would rather say that maybe the qcom drivers/clk/qcom/* file
> should be exporting a PWM from the linux side of things
> rather than a clock for this thingie, and adding #pwm-cells
> in the DT node for the clock controller, making it possible
> to obtain PWMs right out of it, if it is a single device node for
> the whole thing.
> 
> Analogous to how we have GPIOs that are ortogonally interrupt
> providers I don't see any big problem in a clock controller
> being clock and PWM provider at the same time.
> 
> There is code in drivers/clk/clk-pwm to use a pwm as a clock
> but that is kind of the reverse use case, if we implement PWMs
> directly in a clock controller driver then these can be turned into
> clocks using clk-pwm.c should it be needed, right?
> 
> Part of me start to question whether clk and pwm should even
> be separate subsystems :/ they seem to solve an overlapping
> problem space.

My first revision of this vibrator driver used the Linux PWM framework
due to the variable duty cycle:

https://lore.kernel.org/lkml/20180926235112.25710-1-masneyb@xxxxxxxxxxxxx/

I used the pwm-vibra driver on the input side.

Brian