[PATCH 3/4] net: stmmac: modify default value of tx-frames

[Biao Huang]

the default value of tx-frames is 25, it's too late when
passing tstamp to stack, then the ptp4l will fail:

ptp4l -i eth0 -f gPTP.cfg -m
ptp4l: selected /dev/ptp0 as PTP clock
ptp4l: port 1: INITIALIZING to LISTENING on INITIALIZE
ptp4l: port 0: INITIALIZING to LISTENING on INITIALIZE
ptp4l: port 1: link up
ptp4l: timed out while polling for tx timestamp
ptp4l: increasing tx_timestamp_timeout may correct this issue,
       but it is likely caused by a driver bug
ptp4l: port 1: send peer delay response failed
ptp4l: port 1: LISTENING to FAULTY on FAULT_DETECTED (FT_UNSPECIFIED)

ptp4l tests pass when changing the tx-frames from 25 to 1 with
ethtool -C option.
It should be fine to set tx-frames default value to 1, so ptp4l will pass
by default.

Signed-off-by: Biao Huang <biao.huang@xxxxxxxxxxxx>
---
 drivers/net/ethernet/stmicro/stmmac/common.h |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/common.h b/drivers/net/ethernet/stmicro/stmmac/common.h
index 26bbcd8..6a08cec 100644
--- a/drivers/net/ethernet/stmicro/stmmac/common.h
+++ b/drivers/net/ethernet/stmicro/stmmac/common.h
@@ -261,7 +261,7 @@ struct stmmac_safety_stats {
 #define STMMAC_COAL_TX_TIMER	1000
 #define STMMAC_MAX_COAL_TX_TICK	100000
 #define STMMAC_TX_MAX_FRAMES	256
-#define STMMAC_TX_FRAMES	25
+#define STMMAC_TX_FRAMES	1
 
 /* Packets types */
 enum packets_types {
-- 
1.7.9.5