Re: [PATCH 0/4] cpufreq support for the Raspberry Pi

[Nicolas Saenz Julienne]

Hi Stefan,
thanks for the review, I took note of your code comments.

On Wed, 2019-06-05 at 11:46 +0200, Stefan Wahren wrote:
> Hi Nicolas,
> 
> Am 04.06.19 um 19:32 schrieb Nicolas Saenz Julienne:
> > Hi all,
> > this series aims at adding cpufreq support to the Raspberry Pi family of
> > boards.
> > 
> > The previous revision can be found at: https://lkml.org/lkml/2019/5/20/431
> > 
> > The series first factors out 'pllb' from clk-bcm2385 and creates a new
> > clk driver that operates it over RPi's firmware interface[1]. We are
> > forced to do so as the firmware 'owns' the pll and we're not allowed to
> > change through the register interface directly as we might race with the
> > over-temperature and under-voltage protections provided by the firmware.
> it would be nice to preserve such design decision in the driver as a
> comment, because the cover letter usually get lost.
> > Next it creates a minimal cpufreq driver that populates the CPU's opp
> > table, and registers cpufreq-dt. Which is needed as the firmware
> > controls the max and min frequencies available.
> 
> I tested your series on top of Linux 5.2-rc1 with multi_v7_defconfig and
> manually enable this drivers. During boot with Raspbian rootfs i'm
> getting the following:
> 
> [    1.177009] cpu cpu0: failed to get clock: -2
> [    1.183643] cpufreq-dt: probe of cpufreq-dt failed with error -2

This is surprising, who could be creating a platform_device for cpufreq-dt
apart from raspberrypi-cpufreq? Just to make things clear, you're using the
device tree from v5.2-rc1 (as opposed to the Raspbian one)?

> [    1.192117] sdhci: Secure Digital Host Controller Interface driver
> [    1.198725] sdhci: Copyright(c) Pierre Ossman
> [    1.207005] Synopsys Designware Multimedia Card Interface Driver
> [    1.319936] sdhost-bcm2835 3f202000.mmc: loaded - DMA enabled (>1)
> [    1.326641] sdhci-pltfm: SDHCI platform and OF driver helper
> [    1.336568] ledtrig-cpu: registered to indicate activity on CPUs
> [    1.343713] usbcore: registered new interface driver usbhid
> [    1.350275] usbhid: USB HID core driver
> [    1.357639] bcm2835-mbox 3f00b880.mailbox: mailbox enabled
> [    1.367490] NET: Registered protocol family 10
> [    1.375013] Segment Routing with IPv6
> [    1.381696] sit: IPv6, IPv4 and MPLS over IPv4 tunneling driver
> [    1.388980] NET: Registered protocol family 17
> [    1.395624] can: controller area network core (rev 20170425 abi 9)
> [    1.402358] NET: Registered protocol family 29
> [    1.408997] can: raw protocol (rev 20170425)
> [    1.415599] can: broadcast manager protocol (rev 20170425 t)
> [    1.422219] can: netlink gateway (rev 20170425) max_hops=1
> [    1.429369] Key type dns_resolver registered
> [    1.437190] Registering SWP/SWPB emulation handler
> [    1.444443] Loading compiled-in X.509 certificates
> [    1.455693] 3f201000.serial: ttyAMA0 at MMIO 0x3f201000 (irq = 81,
> base_baud = 0) is a PL011 rev2
> [    1.462768] serial serial0: tty port ttyAMA0 registered
> [    1.478755] mmc0: host does not support reading read-only switch,
> assuming write-enable
> [    1.488792] mmc0: new high speed SDHC card at address 0007
> [    1.495766] raspberrypi-firmware soc:firmware: Attached to firmware
> from 2019-03-27 15:45
> [    1.496862] mmcblk0: mmc0:0007 SDCIT 14.6 GiB
> [    1.512768] raspberrypi-clk raspberrypi-clk: CPU frequency range: min
> 600000000, max 1400000000
> [    1.513012]  mmcblk0: p1 p2
> [    1.558085] dwc2 3f980000.usb: 3f980000.usb supply vusb_d not found,
> using dummy regulator
> [    1.565355] dwc2 3f980000.usb: 3f980000.usb supply vusb_a not found,
> using dummy regulator
> [    1.623246] dwc2 3f980000.usb: DWC OTG Controller
> [    1.630318] dwc2 3f980000.usb: new USB bus registered, assigned bus
> number 1
> [    1.637439] dwc2 3f980000.usb: irq 33, io mem 0x3f980000
> [    1.645268] hub 1-0:1.0: USB hub found
> [    1.652317] hub 1-0:1.0: 1 port detected
> [    1.665867] sdhci-iproc 3f300000.sdhci: allocated mmc-pwrseq
> [    1.704788] mmc1: SDHCI controller on 3f300000.sdhci [3f300000.sdhci]
> using PIO
> [    1.717694] hctosys: unable to open rtc device (rtc0)
> [    1.724967] sysfs: cannot create duplicate filename
> '/devices/platform/cpufreq-dt'

For the record, this is raspberrypi-cpufreq creating the platform device for
cpufreq-dt.

> [    1.732120] CPU: 1 PID: 1 Comm: swapper/0 Not tainted
> 5.2.0-rc1-00004-g5aa6d98-dirty #2
> [    1.739288] Hardware name: BCM2835
> [    1.746421] [<c0312304>] (unwind_backtrace) from [<c030cc08>]
> (show_stack+0x10/0x14)
> [    1.753636] [<c030cc08>] (show_stack) from [<c0e7d358>]
> (dump_stack+0xb4/0xc8)
> [    1.760840] [<c0e7d358>] (dump_stack) from [<c0503b64>]
> (sysfs_warn_dup+0x58/0x64)
> [    1.768105] [<c0503b64>] (sysfs_warn_dup) from [<c0503c8c>]
> (sysfs_create_dir_ns+0xd8/0xe8)
> [    1.775481] [<c0503c8c>] (sysfs_create_dir_ns) from [<c0e82520>]
> (kobject_add_internal+0xb0/0x2fc)
> [    1.782958] [<c0e82520>] (kobject_add_internal) from [<c0e827c8>]
> (kobject_add+0x5c/0xc0)
> [    1.790534] [<c0e827c8>] (kobject_add) from [<c096b1cc>]
> (device_add+0xf8/0x608)
> [    1.798180] [<c096b1cc>] (device_add) from [<c0971098>]
> (platform_device_add+0x110/0x214)
> [    1.805945] [<c0971098>] (platform_device_add) from [<c0971ae4>]
> (platform_device_register_full+0x130/0x148)
> [    1.813866] [<c0971ae4>] (platform_device_register_full) from
> [<c15a7a30>] (raspberrypi_cpufreq_driver_init+0x128/0x178)
> [    1.821916] [<c15a7a30>] (raspberrypi_cpufreq_driver_init) from
> [<c0302eec>] (do_one_initcall+0x54/0x21c)
> [    1.830099] [<c0302eec>] (do_one_initcall) from [<c15010f8>]
> (kernel_init_freeable+0x244/0x2e0)
> [    1.838312] [<c15010f8>] (kernel_init_freeable) from [<c0e949d4>]
> (kernel_init+0x8/0x10c)
> [    1.846541] [<c0e949d4>] (kernel_init) from [<c03010e8>]
> (ret_from_fork+0x14/0x2c)
> [    1.854783] Exception stack(0xea89dfb0 to 0xea89dff8)
> [    1.863036] dfa0:                                     00000000
> 00000000 00000000 00000000
> [    1.871450] dfc0: 00000000 00000000 00000000 00000000 00000000
> 00000000 00000000 00000000
> [    1.879860] dfe0: 00000000 00000000 00000000 00000000 00000013 00000000
> [    1.888251] kobject_add_internal failed for cpufreq-dt with -EEXIST,
> don't try to register things with the same name in the same directory.
> [    1.896910] cpu cpu0: Failed to create platform device, -17

Regards,
Nicolas

Attachment: signature.asc
Description: This is a digitally signed message part