EXTERNAL MAILIn general IP is configurable. There are a lot of configurations options.
On Tue, Feb 19, 2019 at 04:19:20PM +0000, Piotr Sroka wrote:
Signed-off-by: Piotr Sroka <piotrs@xxxxxxxxxxx>
---
Changes for v2:
- remove chip dependends parameters from dts bindings
- add names for register ranges in dts bindings
- add generic bindings to describe NAND chip representation
under the NAND controller node
---
.../bindings/mtd/cadence-nand-controller.txt | 48 ++++++++++++++++++++++
1 file changed, 48 insertions(+)
create mode 100644 Documentation/devicetree/bindings/mtd/cadence-nand-controller.txt
diff --git a/Documentation/devicetree/bindings/mtd/cadence-nand-controller.txt b/Documentation/devicetree/bindings/mtd/cadence-nand-controller.txt
new file mode 100644
index 000000000000..3d9b4decae24
--- /dev/null
+++ b/Documentation/devicetree/bindings/mtd/cadence-nand-controller.txt
@@ -0,0 +1,48 @@
+* Cadence NAND controller
+
+Required properties:
+ - compatible : "cdns,hpnfc"
Only one version of IP or is that discoverable?
+ - reg : Contains two entries, each of which is a tuple consisting of a
+ physical address and length. The first entry is the address and
+ length of the controller register set. The second entry is the
+ address and length of the Slave DMA data port.
+ - reg-names: should contain "cadence_reg" and "cadence_sdma"
'cadence_' part is pointless.
+ - interrupts : The interrupt number.
+ - clocks: phandle of the controller core clock (nf_clk).
+ - Children nodes represent the available NAND chips.
Need a blank line and remove the '-' as it's not a property.
+
+Required properties of NAND chips:
+ - reg: shall contain the native Chip Select ids from 0 to max supported by
+ the cadence nand flash controller
+
+Optional properties:
For child nodes? If not move before child nodes.
+ - dmas: shall reference DMA channel associated to the NAND controller
+ - cdns,board-delay : Estimated Board delay. The value includes the total
+ round trip delay for the signals and is used for deciding on values
+ associated with data read capture. The example formula for SDR mode is
+ the following:
+ board_delay = RE#PAD_delay + PCB trace to device + PCB trace from device
+ + DQ PAD delay
Units? Use unit suffix as defined in property-units.txt.
+
+See Documentation/devicetree/bindings/mtd/nand.txt for more details on
+generic bindings.
+
+Example:
+
+nand_controller: nand-controller @60000000 {
space ^
+ compatible = "cdns,hpnfc";
+ reg = <0x60000000 0x10000>, <0x80000000 0x10000>;
+ reg-names = "cadence_reg", "cadence_sdma";
+ clocks = <&nf_clk>;
+ cdns,board-delay = <4830>;
+ interrupts = <2 0>;
+ nand@0 {
+ reg = <0>;
+ label = "nand-1";
+ };
+ nand@1 {
+ reg = <1>;
+ label = "nand-2";
+ };
+
+};
--
2.15.0