RE: [PATCH] regulator: da9062: Adjust LDO voltage selection minimum value

[Steve Twiss]

Hi Felix,

On 13 June 2019 14:02, Felix Riemann wrote:

> Subject: [PATCH] regulator: da9062: Adjust LDO voltage selection minimum value
> 
> According to the datasheet the LDO's voltage selection registers have
> a minimum value of 0x2. This offset was not observed by the driver,
> causing the LDO output being two steps (= 0.1V) lower than requested.
> 
> Signed-off-by: Felix Riemann <felix.riemann@xxxxxx>

Uh.

That looks right. But I want to take a closer look tomorrow along with my
tests, which must pass this behaviour.

Give me a day or two please.

Regards,
Steve