Re: [PATCH v5 4/5] net: macb: add support for high speed interface

[Russell King - ARM Linux admin]

On Tue, Jun 25, 2019 at 08:49:33AM +0000, Parshuram Raju Thombare wrote:
> >>  	switch (state->interface) {
> >>  	case PHY_INTERFACE_MODE_NA:
> >> +	case PHY_INTERFACE_MODE_USXGMII:
> >> +	case PHY_INTERFACE_MODE_10GKR:
> >> +		if (bp->caps & MACB_CAPS_GIGABIT_MODE_AVAILABLE) {
> >> +			phylink_set(mask, 10000baseCR_Full);
> >> +			phylink_set(mask, 10000baseER_Full);
> >> +			phylink_set(mask, 10000baseKR_Full);
> >> +			phylink_set(mask, 10000baseLR_Full);
> >> +			phylink_set(mask, 10000baseLRM_Full);
> >> +			phylink_set(mask, 10000baseSR_Full);
> >> +			phylink_set(mask, 10000baseT_Full);
> >> +			phylink_set(mask, 5000baseT_Full);
> >> +			phylink_set(mask, 2500baseX_Full);
> >> +			phylink_set(mask, 1000baseX_Full);
> >> +		}
> >If MACB_CAPS_GIGABIT_MODE_AVAILABLE is not set, are these interface
> >modes supported by the hardware?  If the PHY interface mode is not
> >supported, then the returned support mask must be cleared.[] 
> There are some configs which uses this macro to limit data rate to 100M 
> even if hardware support higher rates.

I'm sorry, this response does not address my statement, maybe I wasn't
clear enough.  I am asking about the *PHY* interface modes, in
other words (e.g.) PHY_INTERFACE_MODE_USXGMII.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 12.1Mbps down 622kbps up
According to speedtest.net: 11.9Mbps down 500kbps up