[PATCH] md-multipath: Replace a seq_printf() call by seq_putc() in multipath_status()

[Markus Elfring]

From: Markus Elfring <elfring@xxxxxxxxxxxxxxxxxxxxx>
Date: Mon, 1 Jul 2019 13:07:55 +0200

A single character (depending on a condition check) should be put
into a sequence. Thus use the corresponding function âseq_putcâ.

This issue was detected by using the Coccinelle software.

Signed-off-by: Markus Elfring <elfring@xxxxxxxxxxxxxxxxxxxxx>
---
 drivers/md/md-multipath.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/md/md-multipath.c b/drivers/md/md-multipath.c
index 6780938d2991..3bf6f97ea264 100644
--- a/drivers/md/md-multipath.c
+++ b/drivers/md/md-multipath.c
@@ -146,7 +146,8 @@ static void multipath_status(struct seq_file *seq, struct mddev *mddev)
 	rcu_read_lock();
 	for (i = 0; i < conf->raid_disks; i++) {
 		struct md_rdev *rdev = rcu_dereference(conf->multipaths[i].rdev);
-		seq_printf (seq, "%s", rdev && test_bit(In_sync, &rdev->flags) ? "U" : "_");
+		seq_putc(seq,
+			 rdev && test_bit(In_sync, &rdev->flags) ? 'U' : '_');
 	}
 	rcu_read_unlock();
 	seq_putc(seq, ']');
--
2.22.0