[PATCH 3/4] gpio: stp-xway: get rid of the #include <lantiq_soc.h> dependency

[Martin Blumenstingl]

Use the xway_stp_{r,w}32 helpers in xway_stp_w32_mask instead of relying
on ltq_{r,w}32 from the architecture specific <lantiq_soc.h>.
This will allow the driver to be compile-tested on all architectures
that support MMIO.

Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
---
 drivers/gpio/gpio-stp-xway.c | 5 +----
 1 file changed, 1 insertion(+), 4 deletions(-)

diff --git a/drivers/gpio/gpio-stp-xway.c b/drivers/gpio/gpio-stp-xway.c
index b31e08f84681..9e23a5ae8108 100644
--- a/drivers/gpio/gpio-stp-xway.c
+++ b/drivers/gpio/gpio-stp-xway.c
@@ -15,8 +15,6 @@
 #include <linux/clk.h>
 #include <linux/err.h>
 
-#include <lantiq_soc.h>
-
 /*
  * The Serial To Parallel (STP) is found on MIPS based Lantiq socs. It is a
  * peripheral controller used to drive external shift register cascades. At most
@@ -71,8 +69,7 @@
 #define xway_stp_r32(m, reg)		__raw_readl(m + reg)
 #define xway_stp_w32(m, val, reg)	__raw_writel(val, m + reg)
 #define xway_stp_w32_mask(m, clear, set, reg) \
-		ltq_w32((ltq_r32(m + reg) & ~(clear)) | (set), \
-		m + reg)
+		xway_stp_w32(m, (xway_stp_r32(m, reg) & ~(clear)) | (set), reg)
 
 struct xway_stp {
 	struct gpio_chip gc;
-- 
2.22.0