RE: [PATCH v1 net-next] net: stmmac: enable clause 45 mdio support

[Voon, Weifeng]

> > > > @@ -155,22 +171,26 @@ static int stmmac_mdio_read(struct mii_bus
> > > > *bus,
> > > int phyaddr, int phyreg)
> > > >  	struct stmmac_priv *priv = netdev_priv(ndev);
> > > >  	unsigned int mii_address = priv->hw->mii.addr;
> > > >  	unsigned int mii_data = priv->hw->mii.data;
> > > > -	u32 v;
> > > > -	int data;
> > > >  	u32 value = MII_BUSY;
> > > > +	int data = 0;
> > > > +	u32 v;
> > > >
> > > >  	value |= (phyaddr << priv->hw->mii.addr_shift)
> > > >  		& priv->hw->mii.addr_mask;
> > > >  	value |= (phyreg << priv->hw->mii.reg_shift) & priv->hw-
> > > >mii.reg_mask;
> > > >  	value |= (priv->clk_csr << priv->hw->mii.clk_csr_shift)
> > > >  		& priv->hw->mii.clk_csr_mask;
> > > > -	if (priv->plat->has_gmac4)
> > > > +	if (priv->plat->has_gmac4) {
> > > >  		value |= MII_GMAC4_READ;
> > > > +		if (phyreg & MII_ADDR_C45)
> > > > +			stmmac_mdio_c45_setup(priv, phyreg, &value, &data);
> > > > +	}
> > > >
> > > >  	if (readl_poll_timeout(priv->ioaddr + mii_address, v, !(v &
> > > MII_BUSY),
> > > >  			       100, 10000))
> > > >  		return -EBUSY;
> > > >
> > > > +	writel(data, priv->ioaddr + mii_data);
> > >
> > > That looks odd. Could you explain why it is needed.
> > >
> > > Thanks
> > > 	Andrew
> >
> > Hi Andrew,
> > This mdio c45 support needed to access DWC xPCS which is a Clause-45
> 
> I mean it looks odd doing a write to the data register in the middle of
> stmmac_mdio_read().

MAC is using an indirect access to access mdio devices. In order to read,
the driver needs to write into both mii_data and mii_address to select 
c45, read/write command, phy address, address to read, and etc. 

Weifeng