Re: [PATCH v9 2/6] usb:gadget Separated decoding functions from dwc3 driver.

[Greg KH]

On Fri, Jul 05, 2019 at 11:57:14AM +0100, Pawel Laszczak wrote:
> Patch moves some decoding functions from driver/usb/dwc3/debug.h driver
> to driver/usb/gadget/debug.c file. These moved functions include:
>     dwc3_decode_get_status
>     dwc3_decode_set_clear_feature
>     dwc3_decode_set_address
>     dwc3_decode_get_set_descriptor
>     dwc3_decode_get_configuration
>     dwc3_decode_set_configuration
>     dwc3_decode_get_intf
>     dwc3_decode_set_intf
>     dwc3_decode_synch_frame
>     dwc3_decode_set_sel
>     dwc3_decode_set_isoch_delay
>     dwc3_decode_ctrl
> 
> These functions are used also in inroduced cdns3 driver.
> 
> All functions prefixes were changed from dwc3 to usb.
> Also, function's parameters has been extended according to the name
> of fields in standard SETUP packet.
> Additionally, patch adds usb_decode_ctrl function to
> include/linux/usb/gadget.h file.

No it does not :(

> Signed-off-by: Pawel Laszczak <pawell@xxxxxxxxxxx>
> ---
>  drivers/usb/common/Makefile |   5 +
>  drivers/usb/common/debug.c  | 268 ++++++++++++++++++++++++++++++++++++
>  drivers/usb/dwc3/debug.h    | 252 ---------------------------------
>  drivers/usb/dwc3/trace.h    |   2 +-
>  include/linux/usb/ch9.h     |  25 ++++
>  5 files changed, 299 insertions(+), 253 deletions(-)
>  create mode 100644 drivers/usb/common/debug.c
> 
> diff --git a/drivers/usb/common/Makefile b/drivers/usb/common/Makefile
> index 0a7c45e85481..cdc66b59a6f0 100644
> --- a/drivers/usb/common/Makefile
> +++ b/drivers/usb/common/Makefile
> @@ -5,6 +5,11 @@
>  
>  obj-$(CONFIG_USB_COMMON)	  += usb-common.o
>  usb-common-y			  += common.o
> +
> +ifneq ($(CONFIG_TRACING),)
> +	usb-common-y		  += debug.o
> +endif

So only enable this if tracing is not emabled?  Or if enabled?  I'm
confused, isn't there an easier way to write this?

thanks,

greg k-h