[PATCH v3 2/9] dt-bindings: i2c: add bindings for i2c analog and digital filter

[Eugen.Hristev]

From: Eugen Hristev <eugen.hristev@xxxxxxxxxxxxx>

Some i2c controllers have a built-in digital or analog filter.
This is specifically required depending on the hardware PCB/board.
Some controllers also allow specifying the maximum width of the
spikes that can be filtered. The width length can be specified in nanoseconds.

Signed-off-by: Eugen Hristev <eugen.hristev@xxxxxxxxxxxxx>
---
 Documentation/devicetree/bindings/i2c/i2c.txt | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/Documentation/devicetree/bindings/i2c/i2c.txt b/Documentation/devicetree/bindings/i2c/i2c.txt
index 44efafd..a2d31aa 100644
--- a/Documentation/devicetree/bindings/i2c/i2c.txt
+++ b/Documentation/devicetree/bindings/i2c/i2c.txt
@@ -55,6 +55,17 @@ wants to support one of the below features, it should adapt the bindings below.
 	Number of nanoseconds the SDA signal takes to fall; t(f) in the I2C
 	specification.
 
+- i2c-ana-filter
+	Enable analog filter for i2c lines.
+
+- i2c-dig-filter
+	Enable digital filter for i2c lines.
+
+- i2c-filter-width-ns
+	Width of spikes which can be filtered by either digital or analog
+	filters (i2c-ana-filtr or i2c-dig-filtr). This width is specified
+	in nanoseconds.
+
 - interrupts
 	interrupts used by the device.
 
-- 
2.7.4