Re: [PATCH 1/3] platform/x86/pcengines-apuv2: add mpcie reset gpio export

[Florian Eckert]

On 2019-07-08 21:44, Enrico Weigelt, metux IT consult wrote:
> On 04.07.19 11:02, Florian Eckert wrote:
> > On APUx we have also mpcie2/mpcie3 reset pins. To make it possible to 
> > reset
> > the ports from the userspace, add the definition to this platform
> > device. The gpio can then be exported by the legancy gpio subsystem to
> > toggle the mpcie reset pin.
>
> Are you sure they're also available on APUv2 (not just v3) ?

We have the following models on APU2 family:
The schematic could be downloaded for all APU2 family boards from this 
side.
See https://www.pcengines.ch/apu2.htm

They all use the similar PCB with some minimal changes.

APU2
2 mpcie slot
apu2d0 (2 GB DRAM, 2 i211AT NICs)
apu2d2 (2 GB DRAM, 3 i211AT NICs)
apu2d4 (4 GB DRAM, 3 i210AT NICs)

J14 (USB + SIM1) PE3_RST to GPIO G51
J13 (USB + SIM2) PE4_RST to GPIO G55

APU3
3 mpcie slot
apu3c2 (2 GB DRAM, 3 i211AT NICs, optimized for 3G/LTE modems)
apu3c4 (4 GB DRAM, 3 i211AT NICs, optimized for 3G/LTE modems)

J16 (PCIe + USB no SIM) not connected to a userland GPIO
J15 (USB SIM1) PE4_RST to GPIO G55
J14 (mSATA or USB SIM2) PE3_RST to GPIO G51

APU4
3 mpcie slot
apu4c2 (2 GB DRAM, 4 i211AT NICs)
apu4c4 (4 GB DRAM, 4 i211AT NICs)

J15 (PCIe + USB no SIM) not connected to a userland GPIO
J14 (USB SIM1) PE4_RST to GPIO G55
J13 (mSATA or USB SIM2) PE3_RST to GPIO G51

Please check again so that I have not done any mistake.

So all USB only mpcie slots could be reseted by a GPIO G51 and G55.

Kind regards

Flo