[PATCH v6 0/5] net: macb: cover letter

[Parshuram Thombare]

Hello !

This is 6th version of patch set containing following patches
for Cadence ethernet controller driver.

1. 0001-net-macb-add-phylink-support.patch
   Replace phylib API's with phylink API's.
2. 0002-net-macb-add-support-for-sgmii-MAC-PHY-interface.patch
   This patch add support for SGMII mode.
3. 0004-net-macb-add-support-for-c45-PHY.patch
   This patch is to support C45 PHY.
4. 0005-net-macb-add-support-for-high-speed-interface
   This patch add support for 10G USXGMII PCS in fixed mode.

Changes in v2:
1. Dropped patch configuring TI PHY DP83867 from
   Cadence PCI wrapper driver.
2. Removed code registering emulated PHY for fixed mode. 
3. Code reformatting as per Andrew's and Florian's suggestions.

Changes in v3:
Based on Russell's suggestions
1. Configure MAC in mac_config only for non in-band modes
2. Handle dynamic phy_mode changes in mac_config
3. Move MAC configurations to mac_config
4. Removed seemingly redundant check for phylink handle
5. Removed code from mac_an_restart and mac_link_state
   now just return -EOPNOTSUPP

Changes in v4:
1. Removed PHY_INTERFACE_MODE_2500BASEX, PHY_INTERFACE_MODE_1000BASEX and
   2.5G PHY_INTERFACE_MODE_SGMII phy modes from supported modes

Changes in v5:
1. Code refactoring

Changes in v6:
1. Allow phylink to validate particular phy_mode support by hardware.
2. Remove device tree parameter and 5G serdes rate for USXGMII

Regards,
Parshuram Thombare

Parshuram Thombare (4):
  net: macb: add phylink support
  net: macb: add support for sgmii MAC-PHY interface
  net: macb: add support for c45 PHY
  net: macb: add support for high speed interface

 drivers/net/ethernet/cadence/Kconfig     |   2 +-
 drivers/net/ethernet/cadence/macb.h      | 115 ++++-
 drivers/net/ethernet/cadence/macb_main.c | 543 ++++++++++++++++-------
 3 files changed, 483 insertions(+), 177 deletions(-)

-- 
2.17.1