[PATCH AUTOSEL 4.14 046/105] regmap: fix bulk writes on paged registers

[Sasha Levin]

From: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>

[ Upstream commit db057679de3e9e6a03c1bcd5aee09b0d25fd9f5b ]

On buses like SlimBus and SoundWire which does not support
gather_writes yet in regmap, A bulk write on paged register
would be silently ignored after programming page.
This is because local variable 'ret' value in regmap_raw_write_impl()
gets reset to 0 once page register is written successfully and the
code below checks for 'ret' value to be -ENOTSUPP before linearising
the write buffer to send to bus->write().

Fix this by resetting the 'ret' value to -ENOTSUPP in cases where
gather_writes() is not supported or single register write is
not possible.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
Signed-off-by: Mark Brown <broonie@xxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
 drivers/base/regmap/regmap.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/base/regmap/regmap.c b/drivers/base/regmap/regmap.c
index 8fd08023c0f5..013d0a2b3ba0 100644
--- a/drivers/base/regmap/regmap.c
+++ b/drivers/base/regmap/regmap.c
@@ -1509,6 +1509,8 @@ int _regmap_raw_write(struct regmap *map, unsigned int reg,
 					     map->format.reg_bytes +
 					     map->format.pad_bytes,
 					     val, val_len);
+	else
+		ret = -ENOTSUPP;
 
 	/* If that didn't work fall back on linearising by hand. */
 	if (ret == -ENOTSUPP) {
-- 
2.20.1