Re: [PATCH] ARM: dts: imx7d: sbc-iot-imx7: add recovery for i2c3/4

[Philippe Schenker]

On Sat, 2019-08-10 at 22:58 +0100, Andrà Draszik wrote:
> On Wed, 07 Aug 2019 08:26:15 +0000, Philippe Schenker wrote:
> > From: Oleksandr Suvorov <oleksandr.suvorov@xxxxxxxxxxx>
> > 
> > - add recovery mode for applicable i2c buses for
> >   Colibri iMX7 module.
> > 
> > Signed-off-by: Oleksandr Suvorov <oleksandr.suvorov@xxxxxxxxxxx>
> > Signed-off-by: Philippe Schenker <philippe.schenker@xxxxxxxxxxx>
> > ---
> > 
> > Changes in v3: None
> > Changes in v2: None
> > 
> >  arch/arm/boot/dts/imx7-colibri.dtsi | 25 +++++++++++++++++++++++--
> >  1 file changed, 23 insertions(+), 2 deletions(-)
> > 
> > diff --git a/arch/arm/boot/dts/imx7-colibri.dtsi
> > b/arch/arm/boot/dts/imx7-colibri.dtsi
> > index a8d992f3e897..2480623c92ff 100644
> > --- a/arch/arm/boot/dts/imx7-colibri.dtsi
> > +++ b/arch/arm/boot/dts/imx7-colibri.dtsi
> > @@ -140,8 +140,12 @@
> > 
> >  &i2c1 {
> >  	clock-frequency = <100000>;
> > -	pinctrl-names = "default";
> > +	pinctrl-names = "default", "gpio";
> >  	pinctrl-0 = <&pinctrl_i2c1 &pinctrl_i2c1_int>;
> > +	pinctrl-1 = <&pinctrl_i2c1_recovery &pinctrl_i2c1_int>;
> > +	scl-gpios = <&gpio1 4 GPIO_ACTIVE_HIGH>;
> 
> scl-gpios should be (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN) since
> commit d2d0ad2aec4a ("i2c: imx: use open drain for recovery GPIO")
> 
> Otherwise you'll get a boot-time warning:
>    enforced open drain please flag it properly in DT/ACPI DSDT/board
> file

Thanks for pointing this out, I added this for v4.

Philippe
> 
> > +	sda-gpios = <&gpio1 5 GPIO_ACTIVE_HIGH>;
> > +
> >  	status = "okay";
> > 
> >  	codec: sgtl5000@a {
> > @@ -242,8 +246,11 @@
> > 
> >  &i2c4 {
> >  	clock-frequency = <100000>;
> > -	pinctrl-names = "default";
> > +	pinctrl-names = "default", "gpio";
> >  	pinctrl-0 = <&pinctrl_i2c4>;
> > +	pinctrl-1 = <&pinctrl_i2c4_recovery>;
> > +	scl-gpios = <&gpio7 8 GPIO_ACTIVE_HIGH>;
> 
> and here, too.
> 
> Cheers,
> AndrÃ