Re: [PATCH V15 00/13] PCI: tegra: Add Tegra194 PCIe support

[Thierry Reding]

On Fri, Aug 09, 2019 at 10:15:56AM +0530, Vidya Sagar wrote:
> Tegra194 has six PCIe controllers based on Synopsys DesignWare core.
> There are two Universal PHY (UPHY) blocks with each supporting 12(HSIO:
> Hisg Speed IO) and 8(NVHS: NVIDIA High Speed) lanes respectively.
> Controllers:0~4 use UPHY lanes from HSIO brick whereas Controller:5 uses
> UPHY lanes from NVHS brick. Lane mapping in HSIO UPHY brick to each PCIe
> controller (0~4) is controlled in XBAR module by BPMP-FW. Since PCIe
> core has PIPE interface, a glue module called PIPE-to-UPHY (P2U) is used
> to connect each UPHY lane (applicable to both HSIO and NVHS UPHY bricks)
> to PCIe controller
> This patch series
> - Adds support for P2U PHY driver
> - Adds support for PCIe host controller
> - Adds device tree nodes each PCIe controllers
> - Enables nodes applicable to p2972-0000 platform
> - Adds helper APIs in Designware core driver to get capability regs offset
> - Adds defines for new feature registers of PCIe spec revision 4
> - Makes changes in DesignWare core driver to get Tegra194 PCIe working
> 
> Testing done on P2972-0000 platform
> - Able to get PCIe link up with on-board Marvel eSATA controller
> - Able to get PCIe link up with NVMe cards connected to M.2 Key-M slot
> - Able to do data transfers with both SATA drives and NVMe cards
> - Able to perform suspend-resume sequence

Do you happen to have a patch for P2972-0000 PCI support? I don't see it
in this series.

Thierry

Attachment: signature.asc
Description: PGP signature