Re: [PATCH] m68k: atari: Rename shifter to shifter_st to avoid conflict

[Linus Walleij]

On Mon, Aug 12, 2019 at 9:30 AM Geert Uytterhoeven <geert@xxxxxxxxxxxxxx> wrote:

> When test-compiling the BCM2835 pin control driver on m68k:
>
>     In file included from arch/m68k/include/asm/io_mm.h:32:0,
>                      from arch/m68k/include/asm/io.h:8,
>                      from include/linux/io.h:13,
>                      from include/linux/irq.h:20,
>                      from include/linux/gpio/driver.h:7,
>                      from drivers/pinctrl/bcm/pinctrl-bcm2835.c:17:
>     drivers/pinctrl/bcm/pinctrl-bcm2835.c: In function 'bcm2711_pull_config_set':
>     arch/m68k/include/asm/atarihw.h:190:22: error: expected identifier or '(' before 'volatile'
>      # define shifter ((*(volatile struct SHIFTER *)SHF_BAS))
>
> "shifter" is a too generic name for a global definition.
>
> As the corresponding definition for Atari TT is already called
> "shifter_tt", fix this by renaming the definition for Atari ST to
> "shifter_st".
>
> Reported-by: kbuild test robot <lkp@xxxxxxxxx>
> Suggested-by: Michael Schmitz <schmitzmic@xxxxxxxxx>
> Signed-off-by: Geert Uytterhoeven <geert@xxxxxxxxxxxxxx>

Finally we can use the sh pfc pin controller on our m68k Atari.

Now if I can only resolder the capacitors on my Atari TT ST
before the board self-destructs I will one day test this.

Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>

Yours,
Linus Walleij