Re: [PATCH 14/22] ARM: omap1: use pci_ioremap_io() for omap_cf

[Arnd Bergmann]

On Wed, Aug 14, 2019 at 9:49 AM Tony Lindgren <tony@xxxxxxxxxxx> wrote:
> * Arnd Bergmann <arnd@xxxxxxxx> [190813 19:34]:
> > On Tue, Aug 13, 2019 at 8:12 PM Aaro Koskinen <aaro.koskinen@xxxxxx> wrote:
> > diff --git a/arch/arm/mach-omap1/hardware.h b/arch/arm/mach-omap1/hardware.h
> > index 232b8deef907..9fc76a3c9e57 100644
> > --- a/arch/arm/mach-omap1/hardware.h
> > +++ b/arch/arm/mach-omap1/hardware.h
> > @@ -61,7 +61,7 @@ static inline u32 omap_cs3_phys(void)
> >
> >  #endif /* ifndef __ASSEMBLER__ */
> >
> > -#define OMAP1_IO_OFFSET                0x01000000      /* Virtual IO
> > = 0xfefb0000 */
> > +#define OMAP1_IO_OFFSET                0x00fb0000      /* Virtual IO
> > = 0xff000000 */
> >  #define OMAP1_IO_ADDRESS(pa)   IOMEM((pa) - OMAP1_IO_OFFSET)
> >
> >  #include "serial.h"
>
> Oh OK yeah sounds like that's the issue.
>
> > There may be additional locations that hardcode the virtual address.
>
> Those should be in mach-omap1/io.c, and I recall innovator had some
> hardcoded fpga address that should also be checked.

I see four boards with hardcoded I/O addresses, but they are all below
the PCI I/O virtual address range, and are not affected by that change.

For the innovator FPGA access, this was ok, it uses the correct address
in the OMAP1_IO_OFFSET range.

        Arnd