Re: [RFC,v2 3/6] media: dt-bindings: add DS90UB954-Q1 video deserializer

[Luca Ceresoli]

Hi Sakari,

On 10/09/19 10:43, Sakari Ailus wrote:
> Hi Luca,
> 
> On Tue, Jul 23, 2019 at 10:37:20PM +0200, Luca Ceresoli wrote:
> 
> ...
> 
>> +Device node example
>> +-------------------
>> +
>> +&i2c0 {
>> +	deser: deser@3d {
>> +		compatible = "ti,ds90ub954-q1";
>> +		reg-names = "main", "rxport0", "rxport1", "ser0", "ser1";
>> +		reg       = <0x3d>,  <0x40>,    <0x41>,   <0x44>, <0x45>;
>> +		clocks = <&clk_25M>;
>> +		interrupt-parent = <&gic>;
>> +		interrupts = <3 1 IRQ_TYPE_LEVEL_HIGH>;
>> +		reset-gpios = <&gpio_ctl 4 GPIO_ACTIVE_LOW>;
>> +
>> +		i2c-alias-pool = /bits/ 16 <0x4a 0x4b 0x4c 0x4d 0x4e 0x4f>;
>> +
>> +		gpio-controller;
>> +		#gpio-cells = <3>; /* rxport, remote gpio num, flags */
>> +
>> +		ports {
>> +			#address-cells = <1>;
>> +			#size-cells = <0>;
>> +
>> +			port@0 {
>> +				reg = <0>;
>> +				ds90ub954_fpd3_in0: endpoint {
>> +					remote-endpoint = <&sensor_0_out>;
>> +				};
>> +			};
>> +
>> +			port@1 {
>> +				reg = <1>;
>> +				ds90ub954_fpd3_in1: endpoint {
>> +					remote-endpoint = <&sensor_1_out>;
>> +				};
>> +			};
>> +
>> +			port@2 {
>> +				reg = <2>;
>> +				ds90ub954_mipi_out0: endpoint {
>> +					data-lanes = <1 2 3 4>;
>> +					/* Actually a REFCLK multiplier */
>> +					data-rate = <1600000000>;
> 
> What is data-rate used for? Is it documented somewhere? Could you use
> link-frequencies property instead? It's defined in video-interfaces.txt.

Right, it should be link-frequencies. Thanks for pointing out.

-- 
Luca