Re: [PATCH v2 0/7] add Tegra194 XUSB host and pad controller support

[JC Kuo]

On 10/4/19 8:23 PM, Greg KH wrote:
> On Fri, Oct 04, 2019 at 04:19:34PM +0800, JC Kuo wrote:
>> Hi,
>>
>> This series introduces support for Tegra194 XUSB host and pad
>> controller. Tegra194 XUSB host and pad controller are highly
>> similar to the controllers found on Tegra186. Therefore, it's
>> possible to resue xhci-tegra.c and xusb-tegra186.c for Tegra194.
>>
>> JC Kuo (7):
>>   xhci: tegra: Parameterize mailbox register addresses
>>   usb: host: xhci-tegra: Add Tegra194 XHCI support
>>   phy: tegra: xusb: Protect Tegra186 soc with config
>>   phy: tegra: xusb: Add Tegra194 support
>>   dt-bindings: phy: tegra: Add Tegra194 support
>>   arm64: tegra: Add XUSB and pad controller on Tegra194
>>   arm64: tegra: Enable XUSB host in P2972-0000 board
> 
> What changed from v1?  You need to put that somewhere, usually in the
> patches themselves, below the --- line.
> 
> Or at the very least, in the cover letter.
> 
> Given that I can't find it anywhere here, I'll expect a v3 with that
> information to be sent soon :(
> 
For the first two patches, v2 is identical to v1, sorry that I didn't describe
in patches. For the patches 3 to 7, the individual patch has "Changes in v2:"
session to describe.
I will submit v3 with patch 1 and 2 updated.

Thanks for the guidance,
JC