[PATCH V2 2/2] serial: 8250_omap: Fix gpio check for auto RTS/CTS

[Adam Ford]

There are two checks to see if the manual gpio is configured, but
these the check is seeing if the structure is NULL instead it
should check to see if there are CTS and/or RTS pins defined.

This patch uses checks for those individual pins instead of
checking for the structure itself to restore auto RTS/CTS.

Signed-off-by: Adam Ford <aford173@xxxxxxxxx>
---
V2:  Made the NULL dererence check from patch 1/2 come before this.

diff --git a/drivers/tty/serial/8250/8250_omap.c b/drivers/tty/serial/8250/8250_omap.c
index c68e2b3a1634..836e736ae188 100644
--- a/drivers/tty/serial/8250/8250_omap.c
+++ b/drivers/tty/serial/8250/8250_omap.c
@@ -141,7 +141,7 @@ static void omap8250_set_mctrl(struct uart_port *port, unsigned int mctrl)
 
 	serial8250_do_set_mctrl(port, mctrl);
 
-	if (!up->gpios) {
+	if (!mctrl_gpio_to_gpiod(up->gpios, UART_GPIO_RTS)) {
 		/*
 		 * Turn off autoRTS if RTS is lowered and restore autoRTS
 		 * setting if RTS is raised
@@ -456,7 +456,8 @@ static void omap_8250_set_termios(struct uart_port *port,
 	up->port.status &= ~(UPSTAT_AUTOCTS | UPSTAT_AUTORTS | UPSTAT_AUTOXOFF);
 
 	if (termios->c_cflag & CRTSCTS && up->port.flags & UPF_HARD_FLOW &&
-	    !up->gpios) {
+	    !mctrl_gpio_to_gpiod(up->gpios, UART_GPIO_RTS) &&
+	    !mctrl_gpio_to_gpiod(up->gpios, UART_GPIO_CTS)) {
 		/* Enable AUTOCTS (autoRTS is enabled when RTS is raised) */
 		up->port.status |= UPSTAT_AUTOCTS | UPSTAT_AUTORTS;
 		priv->efr |= UART_EFR_CTS;
-- 
2.17.1