Re: [PATCH v2 2/3] pinctrl: meson-a1: add pinctrl driver for Meson A1 Soc

[Qianggui Song]

Hi,Neil

On 2019/10/8 21:07, Neil Armstrong wrote:
> Hi,
> 
> On 08/10/2019 13:09, Qianggui Song wrote:
>> Add pinctrl driver for Meson A1 Soc which share the same register layout of
>> pinmux with previous Meson-G12A, however there is difference for gpio
>> and pin config register in A1.The main difference is that registers before A1
>> are grouped by function while those of A1 are by bank. The new register layout
>> is as below:
>>
>> /* first bank */	      /* addr */
>> - P_PADCTRL_GPIOP_I         base + 0x00 << 2
>> - P_PADCTRL_GPIOP_O         base + 0x01 << 2
>> - P_PADCTRL_GPIOP_OEN       base + 0x02 << 2
>> - P_PADCTRL_GPIOP_PULL_EN   base + 0x03 << 2
>> - P_PADCTRL_GPIOP_PULL_UP   base + 0x04 << 2
>> - P_PADCTRL_GPIOP_DS        base + 0x05 << 2
>>
>> /* second bank */
>> - P_PADCTRL_GPIOB_I         base + 0x10 << 2
>> - P_PADCTRL_GPIOB_O         base + 0x11 << 2
>> - P_PADCTRL_GPIOB_OEN       base + 0x12 << 2
>> - P_PADCTRL_GPIOB_PULL_EN   base + 0x13 << 2
>> - P_PADCTRL_GPIOB_PULL_UP   base + 0x14 << 2
>> - P_PADCTRL_GPIOB_DS        base + 0x15 << 2
>>
>> Each bank contains at least 6 registers to be configured, if one bank has
>> more than 16 gpios, an extra P_PADCTRL_GPIO[X]_DS_EXT is included. Between
>> two adjacent P_PADCTRL_GPIO[X]_I, there is an offset 0x10, that is to say,
>> for third bank, the offsets will be 0x20,0x21,0x22,0x23,0x24,0x25 according
>> to above register layout.For privous chips, registers are grouped
>> according to their functions while registers of A1 are according to bank.
>>
>> Current Meson pinctrl driver can cover such change by using base address of
>> GPIO as that of drive-strength. While simply giving reg_ds = reg_pullen
>> make wrong value to reg_ds for Socs that do not support drive-strength like
>> AXG.To make things simple, add an extra dt parser function for a1 or later chip
>> and remain the old dt parser function for old Socs.
>>
>> Also note that there is no AO bank in A1.
>>
>> Signed-off-by: Qianggui Song <qianggui.song@xxxxxxxxxxx>
>> ---
>>  drivers/pinctrl/meson/Kconfig            |   6 +
>>  drivers/pinctrl/meson/Makefile           |   1 +
>>  drivers/pinctrl/meson/pinctrl-meson-a1.c | 942 +++++++++++++++++++++++++++++++
>>  drivers/pinctrl/meson/pinctrl-meson.c    |  16 +-
>>  drivers/pinctrl/meson/pinctrl-meson.h    |   5 +
>>  5 files changed, 969 insertions(+), 1 deletion(-)
>>  create mode 100644 drivers/pinctrl/meson/pinctrl-meson-a1.c
>>
> 
> [...]
> 
>> --- a/drivers/pinctrl/meson/pinctrl-meson.c
>> +++ b/drivers/pinctrl/meson/pinctrl-meson.c
>> @@ -695,6 +695,17 @@ static int meson_pinctrl_parse_dt(struct meson_pinctrl *pc,
>>  	return 0;
>>  }
>>  
>> +int meson_pinctrl_parse_dt_extra(struct meson_pinctrl *pc,
>> +				 struct device_node *node)
>> +{
>> +	int ret;
>> +
>> +	ret = meson_pinctrl_parse_dt(pc, node);
>> +	pc->reg_ds = pc->reg_pullen;
>> +
>> +	return ret;
>> +}
>> +
>>  int meson_pinctrl_probe(struct platform_device *pdev)
>>  {
>>  	struct device *dev = &pdev->dev;
>> @@ -708,7 +719,10 @@ int meson_pinctrl_probe(struct platform_device *pdev)
>>  	pc->dev = dev;
>>  	pc->data = (struct meson_pinctrl_data *) of_device_get_match_data(dev);
>>  
>> -	ret = meson_pinctrl_parse_dt(pc, dev->of_node);
>> +	if (pc->data->parse_dt)
>> +		ret = pc->data->parse_dt(pc, dev->of_node);
>> +	else
>> +		ret = meson_pinctrl_parse_dt(pc, dev->of_node);
>>  	if (ret)
>>  		return ret;
>>  
>> diff --git a/drivers/pinctrl/meson/pinctrl-meson.h b/drivers/pinctrl/meson/pinctrl-meson.h
>> index c696f3241a36..ca29efd90aac 100644
>> --- a/drivers/pinctrl/meson/pinctrl-meson.h
>> +++ b/drivers/pinctrl/meson/pinctrl-meson.h
>> @@ -11,6 +11,7 @@
>>  #include <linux/regmap.h>
>>  #include <linux/types.h>
>>  
>> +struct meson_pinctrl;
>>  /**
>>   * struct meson_pmx_group - a pinmux group
>>   *
>> @@ -114,6 +115,7 @@ struct meson_pinctrl_data {
>>  	unsigned int num_banks;
>>  	const struct pinmux_ops *pmx_ops;
>>  	void *pmx_data;
>> +	int (*parse_dt) (struct meson_pinctrl *pc, struct device_node *node);
>>  };
>>  
>>  struct meson_pinctrl {
>> @@ -171,3 +173,6 @@ int meson_pmx_get_groups(struct pinctrl_dev *pcdev,
>>  
>>  /* Common probe function */
>>  int meson_pinctrl_probe(struct platform_device *pdev);
>> +/* Extra dt parser function for register layout grouped by bank */
>> +int meson_pinctrl_parse_dt_extra(struct meson_pinctrl *pc,
>> +				 struct device_node *node);
>>
> 
> I think you should add this parse_dt callback in a separate patch.
> 
> Neil
> 
> .
> 
OK, will do it in the next patch set.