[PATCH v4 0/8] Introduce max12xx ADC support

[Miquel Raynal]

Hello, here is a patchset updating the existing max1027.c driver (for
10-bit max1027/29/31 ADCs) with a few corrections/improvements and
then introducing their 12-bit cousins named max1227/29/31.

As on my hardware setup the "start conversion" and "end of conversion"
pin are not wired (which is absolutely fine for this chip), I also
updated the driver and the bindings to support optional interrupts. In
this case, triggered buffers are not available and the user must poll
the value from sysfs.

Thanks,
MiquÃl


Changes in v4:
==============
* In the v3, I removed the bindings documentation for the max10xx
  devices, in favor of the trivial devices bindings. Unfortunately, I
  didn't spot that in the following patch adding support for the
  max12xx series, I was adding the compatibles to the trivial devices
  list but also re-introducing the bindings documentation with the
  three new compatibles. Just drop this part of the last patch to only
  have the trivial devices file, not the specific bindings. All the
  rest is the same.

Changes in v3:
==============
* Updated the commit message of the patch adding debugfs read access
  to better explain why I decided to limit the number of bytes read to
  two.
* Updated the macros to define the number of channels per device as
  proposed by Jonathan.
* Re-used the realbits entry instead of adding my own (called .depth).
* Started doing DT-bindings yaml conversion, but realized that after
  the first patch offering the interrupt as optional, the
  documentation was fitting pretty well the trivial devices
  representation. Dropped the specific bindings files and updated the
  trivial devices list instead.

Changes in v2:
==============
* Removed the addition of three compatibles from patch 4 (the
  preparation patch) to add these lines back in patch 5 (the actual
  introduction).


Miquel Raynal (8):
  iio: adc: max1027: Add debugfs register read support
  iio: adc: max1027: Make it optional to use interrupts
  iio: adc: max1027: Reset the device at probe time
  iio: adc: max1027: Prepare the introduction of different resolutions
  iio: adc: max1027: Introduce 12-bit devices support
  dt-bindings: iio: adc: max1027: Mark interrupts as optional
  dt-bindings: Add 1027/1029/1031 SPI ADCs as trivial devices
  dt-bindings: Add max12xx SPI ADC series as trivial devices

 .../bindings/iio/adc/max1027-adc.txt          |  20 --
 .../devicetree/bindings/trivial-devices.yaml  |  12 ++
 drivers/iio/adc/Kconfig                       |   4 +-
 drivers/iio/adc/max1027.c                     | 180 +++++++++++-------
 4 files changed, 125 insertions(+), 91 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/iio/adc/max1027-adc.txt

-- 
2.20.1