Re: [PATCH v2 2/3] PCI: pciehp: Wait for PDS if in-band presence is disabled

[Andy Shevchenko]

On Fri, Oct 11, 2019 at 11:51 PM Stuart Hayes <stuart.w.hayes@xxxxxxxxx> wrote:
>
> From: Alexandru Gagniuc <mr.nuke.me@xxxxxxxxx>
>
> When inband presence is disabled, PDS may come up at any time, or not
> at all. PDS being low may indicate that the card is still mating, and
> we could expect contact bounce to bring down the link as well.
>
> It is reasonable to assume that most cards will mate in a hotplug slot
> in about a second. Thus, when we know PDS only reflects out-of-band
> presence, it's worthwhile to wait the extra second or so to make sure
> the card is properly mated before loading the driver, and to prevent
> the hotplug code from disabling a device if the presence detect change
> goes active after the device is enabled.

Thank you!
My comments below.

> +static void pcie_wait_for_presence(struct pci_dev *pdev)
> +{
> +       int timeout = 1250;

> +       bool pds;

make W=1 will issue a warning. Just remove the line.

> +       u16 slot_status;
> +
> +       do {
> +               pcie_capability_read_word(pdev, PCI_EXP_SLTSTA, &slot_status);
> +               if (!!(slot_status & PCI_EXP_SLTSTA_PDS))
> +                       return;
> +               msleep(10);
> +               timeout -= 10;
> +       } while (timeout > 0);
> +

> +       pci_info(pdev, "Presence Detect state not set in 1250 msec\n");

Perhaps ("%d", timeout) ?

> +}

-- 
With Best Regards,
Andy Shevchenko