Re: [RFC v4 00/18] objtool: Add support for arm64

[RaphaÃl Gault]

Hi Julien,

On 10/14/19 9:37 AM, Julien Thierry wrote:
> On 8/16/19 1:23 PM, Raphael Gault wrote:
>> Hi,
>>
>
> [...]
>
>> As of now, objtool only supports the x86_64 architecture but the
>> groundwork has already been done in order to add support for other
>> architectures without too much effort.
>>
>> This series of patches adds support for the arm64 architecture
>> based on the Armv8.5 Architecture Reference Manual.
>>
>
> I was wondering about the current status of these patches. Is anyone
> actively working on this?
>
> If not, I can pick that up and try to make this go forward.
>

I am not working on these patches at the moment and I don't know when I
can get back at it so as far as I am concerned you can pick it up but
maybe wait a bit to see if someone else has an interest in this.

Thanks,
IMPORTANT NOTICE: The contents of this email and any attachments are confidential and may also be privileged. If you are not the intended recipient, please notify the sender immediately and do not disclose the contents to any other person, use it for any purpose, or store or copy the information in any medium. Thank you.