Re: [PATCH net] net: bcmgenet: Set phydev->dev_flags only for internal PHYs

[Doug Berger]

On 10/11/19 12:57 PM, Florian Fainelli wrote:
> On 10/11/19 12:53 PM, Florian Fainelli wrote:
>> phydev->dev_flags is entirely dependent on the PHY device driver which
>> is going to be used, setting the internal GENET PHY revision in those
>> bits only makes sense when drivers/net/phy/bcm7xxx.c is the PHY driver
>> being used.
>>
>> Fixes: 487320c54143 ("net: bcmgenet: communicate integrated PHY revision to PHY driver")
>> Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
> 
> FWIW, I am preparing net-next material which allows the phy_flags to be
> scoped towards a specific PHY driver, and not broadly applied, but until
> this happens, we should probably go with this change.
> 
>> ---
>>  drivers/net/ethernet/broadcom/genet/bcmmii.c | 5 +++--
>>  1 file changed, 3 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/net/ethernet/broadcom/genet/bcmmii.c b/drivers/net/ethernet/broadcom/genet/bcmmii.c
>> index 970e478a9017..94d1dd5d56bf 100644
>> --- a/drivers/net/ethernet/broadcom/genet/bcmmii.c
>> +++ b/drivers/net/ethernet/broadcom/genet/bcmmii.c
>> @@ -273,11 +273,12 @@ int bcmgenet_mii_probe(struct net_device *dev)
>>  	struct bcmgenet_priv *priv = netdev_priv(dev);
>>  	struct device_node *dn = priv->pdev->dev.of_node;
>>  	struct phy_device *phydev;
>> -	u32 phy_flags;
>> +	u32 phy_flags = 0;
>>  	int ret;
>>  
>>  	/* Communicate the integrated PHY revision */
>> -	phy_flags = priv->gphy_rev;
>> +	if (priv->internal_phy)
>> +		phy_flags = priv->gphy_rev;
>>  
>>  	/* Initialize link state variables that bcmgenet_mii_setup() uses */
>>  	priv->old_link = -1;
>>
> 
> 
Acked-by: Doug Berger <opendmb@xxxxxxxxx>