Re: [PATCH 2/7] PCI/PM: Correct pci_pm_thaw_noirq() documentation

[Rafael J. Wysocki]

On Tuesday, October 15, 2019 1:00:11 AM CEST Bjorn Helgaas wrote:
> From: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>
> 
> According to the documentation, pci_pm_thaw_noirq() did not put the device
> into the full-power state and restore its standard configuration registers.
> This is incorrect, so update the documentation to match the code.
> 
> Signed-off-by: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>

Right, the documentation is outdated, so

Reviewed-by: Rafael J. Wysocki <rafael.j.wysocki@xxxxxxxxx>

> ---
>  Documentation/power/pci.rst | 10 +++++-----
>  1 file changed, 5 insertions(+), 5 deletions(-)
> 
> diff --git a/Documentation/power/pci.rst b/Documentation/power/pci.rst
> index 0e2ef7429304..1525c594d631 100644
> --- a/Documentation/power/pci.rst
> +++ b/Documentation/power/pci.rst
> @@ -600,17 +600,17 @@ using the following PCI bus type's callbacks::
>  
>  respectively.
>  
> -The first of them, pci_pm_thaw_noirq(), is analogous to pci_pm_resume_noirq(),
> -but it doesn't put the device into the full power state and doesn't attempt to
> -restore its standard configuration registers.  It also executes the device
> -driver's pm->thaw_noirq() callback, if defined, instead of pm->resume_noirq().
> +The first of them, pci_pm_thaw_noirq(), is analogous to pci_pm_resume_noirq().
> +It puts the device into the full power state and restores its standard
> +configuration registers.  It also executes the device driver's pm->thaw_noirq()
> +callback, if defined, instead of pm->resume_noirq().
>  
>  The pci_pm_thaw() routine is similar to pci_pm_resume(), but it runs the device
>  driver's pm->thaw() callback instead of pm->resume().  It is executed
>  asynchronously for different PCI devices that don't depend on each other in a
>  known way.
>  
> -The complete phase it the same as for system resume.
> +The complete phase is the same as for system resume.
>  
>  After saving the image, devices need to be powered down before the system can
>  enter the target sleep state (ACPI S4 for ACPI-based systems).  This is done in
>