[RFC][PATCH v3 04/11] dt-bindings: usb: dwc3: Allow clock list & resets to be more flexible

[John Stultz]

Rather then adding another device specific binding to support
hikey960, Rob Herring suggested we expand the current dwc3
binding to allow for variable numbers of clocks and resets.

Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
Cc: Rob Herring <robh+dt@xxxxxxxxxx>
Cc: Mark Rutland <mark.rutland@xxxxxxx>
CC: ShuFan Lee <shufan_lee@xxxxxxxxxxx>
Cc: Heikki Krogerus <heikki.krogerus@xxxxxxxxxxxxxxx>
Cc: Suzuki K Poulose <suzuki.poulose@xxxxxxx>
Cc: Chunfeng Yun <chunfeng.yun@xxxxxxxxxxxx>
Cc: Yu Chen <chenyu56@xxxxxxxxxx>
Cc: Felipe Balbi <balbi@xxxxxxxxxx>
Cc: Hans de Goede <hdegoede@xxxxxxxxxx>
Cc: Andy Shevchenko <andy.shevchenko@xxxxxxxxx>
Cc: Jun Li <lijun.kernel@xxxxxxxxx>
Cc: Valentin Schneider <valentin.schneider@xxxxxxx>
Cc: Jack Pham <jackp@xxxxxxxxxxxxxx>
Cc: linux-usb@xxxxxxxxxxxxxxx
Cc: devicetree@xxxxxxxxxxxxxxx
Suggested-by: Rob Herring <Rob.Herring@xxxxxxx>
Signed-off-by: John Stultz <john.stultz@xxxxxxxxxx>
---
 Documentation/devicetree/bindings/usb/dwc3.txt | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/usb/dwc3.txt b/Documentation/devicetree/bindings/usb/dwc3.txt
index 66780a47ad85..29768b0ca923 100644
--- a/Documentation/devicetree/bindings/usb/dwc3.txt
+++ b/Documentation/devicetree/bindings/usb/dwc3.txt
@@ -7,7 +7,8 @@ Required properties:
  - compatible: must be "snps,dwc3"
  - reg : Address and length of the register set for the device
  - interrupts: Interrupts used by the dwc3 controller.
- - clock-names: should contain "ref", "bus_early", "suspend"
+ - clock-names: list of clock names. Ideally should be "ref",
+                "bus_early", "suspend" but may be less or more.
  - clocks: list of phandle and clock specifier pairs corresponding to
            entries in the clock-names property.
 
@@ -36,7 +37,7 @@ Optional properties:
  - phys: from the *Generic PHY* bindings
  - phy-names: from the *Generic PHY* bindings; supported names are "usb2-phy"
 	or "usb3-phy".
- - resets: a single pair of phandle and reset specifier
+ - resets: set of phandle and reset specifier pairs
  - snps,usb2-lpm-disable: indicate if we don't want to enable USB2 HW LPM
  - snps,usb3_lpm_capable: determines if platform is USB3 LPM capable
  - snps,dis-start-transfer-quirk: when set, disable isoc START TRANSFER command
-- 
2.17.1