Re: [PATCH RFC 3/3] mtd: rawnand: Add support Macronix power down mode
From: masonccyang
Date: Wed Oct 16 2019 - 02:56:05 EST
Hi Miquel,
> >
> > > > > > + nand_select_target(chip, 0);
> > > > >
> > > > > On several NAND controllers there is no way to act on the CS
line
> > > > > without actually writing bytes to the NAND chip. So basically
this
> > > > > is very likely to not work.
> > > >
> > > > any other way to make it work ? GPIO ?
> > > > or just have some comments description here.
> > > > i.e,.
> > > >
> > > > /* The NAND chip will exit the deep power down mode with #CS
toggling,
> >
> > > > * please refer to datasheet for the timing requirement of tCRDP
and
> > tRDP.
> > > > */
> > > >
> > >
> > > Good luck with that. As Miquel said, on most NAND controllers
> > > select_target() is a dummy operation that just assigns
nand_chip->target
> > > to the specified value but doesn't assert the CS line. You could
send a
> > > dummy command here, like a READ_ID, but I guess you need CS to be
> > > asserted for at least 20ns before asserting any other signals
(CLE/ALE)
> > > which might be an issue.
> >
> > okay, got it.
> > But if possible, I think adding CS line control in
nand_select_target()
> > is a simple and generic way for MTD and all raw NAND controllers.
>
> The problem is not that we do not want to; the problem is that
> controllers are not capable of doing it reliably if no byte is sent
> over the NAND bus.
okay, it's kind of pity even though our raw NAND controller is capable of
doing it with no byte is sent over the NAND bus.
As you mentioned that other controllers are not capable of doing it
reliably
if no byte is sent over the NAND bus.
if so, does it work by adding a NAND_OP_DUMMY_INSTR ? (as Boris's
comments)
thanks for your time & comments.
Mason
CONFIDENTIALITY NOTE:
This e-mail and any attachments may contain confidential information
and/or personal data, which is protected by applicable laws. Please be
reminded that duplication, disclosure, distribution, or use of this e-mail
(and/or its attachments) or any part thereof is prohibited. If you receive
this e-mail in error, please notify us immediately and delete this mail as
well as its attachment(s) from your system. In addition, please be
informed that collection, processing, and/or use of personal data is
prohibited unless expressly permitted by personal data protection laws.
Thank you for your attention and cooperation.
Macronix International Co., Ltd.
=====================================================================
============================================================================
CONFIDENTIALITY NOTE:
This e-mail and any attachments may contain confidential information and/or personal data, which is protected by applicable laws. Please be reminded that duplication, disclosure, distribution, or use of this e-mail (and/or its attachments) or any part thereof is prohibited. If you receive this e-mail in error, please notify us immediately and delete this mail as well as its attachment(s) from your system. In addition, please be informed that collection, processing, and/or use of personal data is prohibited unless expressly permitted by personal data protection laws. Thank you for your attention and cooperation.
Macronix International Co., Ltd.
=====================================================================