Re: [PATCH v1 1/4] net: ag71xx: port to phylink

[Oleksij Rempel]

On Wed, Oct 16, 2019 at 02:12:16PM +0200, Andrew Lunn wrote:
> On Mon, Oct 14, 2019 at 08:15:46AM +0200, Oleksij Rempel wrote:
> > The port to phylink was done as close as possible to initial
> > functionality.
> > Theoretically this HW can support flow control, practically seems to be not
> > enough to just enable it. So, more work should be done.
> > 
> > Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
> 
> Hi Oleksij
> 
> Please include Russell King in Cc: in future.

He was included in To:. Do you mean, I need to move him from To to Cc?

> > -static void ag71xx_phy_link_adjust(struct net_device *ndev)
> > +static void ag71xx_mac_validate(struct phylink_config *config,
> > +			    unsigned long *supported,
> > +			    struct phylink_link_state *state)
> >  {
> > -	struct ag71xx *ag = netdev_priv(ndev);
> > +	__ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
> > +
> > +	if (state->interface != PHY_INTERFACE_MODE_NA &&
> > +	    state->interface != PHY_INTERFACE_MODE_GMII &&
> > +	    state->interface != PHY_INTERFACE_MODE_MII) {
> > +		bitmap_zero(supported, __ETHTOOL_LINK_MODE_MASK_NBITS);
> > +		return;
> > +	}
> > +
> > +	phylink_set(mask, MII);
> > +
> > +	/* flow control is not supported */
> >  
> > -	ag71xx_link_adjust(ag, true);
> > +	phylink_set(mask, 10baseT_Half);
> > +	phylink_set(mask, 10baseT_Full);
> > +	phylink_set(mask, 100baseT_Half);
> > +	phylink_set(mask, 100baseT_Full);
> > +
> > +	phylink_set(mask, 1000baseT_Full);
> > +	phylink_set(mask, 1000baseX_Full);
> 
> Can the MAC/PHY dynamically switch between MII and GMII? Maybe you
> should only add 1G support when interface is GMII?

OK, good point.

> > @@ -1239,6 +1255,13 @@ static int ag71xx_open(struct net_device *ndev)
> >  	unsigned int max_frame_len;
> >  	int ret;
> >  
> > +	ret = phylink_of_phy_connect(ag->phylink, ag->pdev->dev.of_node, 0);
> > +	if (ret) {
> > +		netif_info(ag, link, ndev, "phylink_of_phy_connect filed with err: %i\n",
> > +			   ret);
> 
> netif_info seems wrong. _err()?

Yes, will fix it.

Regards,
Oleksij.

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |