Re: [PATCH v6 00/18] Consolidate and improve NVIDIA Tegra CPUIDLE driver(s)
From: Peter De Schrijver
Date: Wed Oct 16 2019 - 15:21:39 EST
On Tue, Oct 15, 2019 at 07:59:57PM +0300, Dmitry Osipenko wrote:
> Hello,
>
> This series does the following:
>
> 1. Unifies Tegra20/30/114 drivers into a single driver and moves it out
> into common drivers/cpuidle/ directory.
>
> 2. Enables CPU cluster power-down idling state on Tegra30.
>
> In the end there is a quite nice clean up of the Tegra CPUIDLE drivers
> and of the Tegra's arch code in general. Please review, thanks!
>
> Changelog:
>
> v6: - Addressed request from Thierry Reding to change the way patches are
> organized by making changes in a more incremental manner.
>
> - tegra_sleep_cpu() now checks for the secondary CPUs to be offline
> in the "Make outer_disable() open-coded" patch.
>
> v5: - Rebased on a recent linux-next, fixed one minor conflict in Kconfig.
>
> - Improved commit's message of the "Support CPU cluster power-down state
> on Tegra30" patch.
>
> - The "Support CPU cluster power-down state on Tegra30" patch is also
> got split and now there is additional "Make outer_disable() open-coded"
> patch.
>
> - Made minor cosmetic changes to the "Introduce unified driver for
> NVIDIA Tegra SoCs" patch by improving error message and renaming
> one variable.
>
> v4: - Fixed compilation with !CONFIG_CACHE_L2X0 (and tested that it still
> works).
>
> - Replaced ktime_compare() with ktime_before() in the new driver,
> for consistency.
>
> v3: - Addressed review comments that were made by Jon Hunter to v2 by
> splitting patches into smaller (and simpler) chunks, better
> documenting changes in the commit messages and using proper error
> codes in the code.
>
> Warnings are replaced with a useful error messages in the code of
> "Introduce unified driver for NVIDIA Tegra SoCs" patch.
>
> Secondary CPUs parking timeout increased to 100ms because I found
> that it actually may happen to take more than 1ms if CPU is running
> on a *very* low frequency.
>
> Added diagnostic messages that are reporting Flow Controller state
> when CPU parking fails.
>
> Further polished cpuidle driver's code.
>
> The coupled state entering is now aborted if there is a pending SGI
> (Software Generated Interrupt) because it will be lost after GIC's
> power-cycling. Like it was done by the old Tegra20 CPUIDLE driver.
>
> v2: - Added patches to enable the new cpuidle driver in the defconfigs:
>
> ARM: multi_v7_defconfig: Enable Tegra cpuidle driver
> ARM: tegra: Enable Tegra cpuidle driver in tegra_defconfig
>
> - Dropped patches that removed CPUIDLE_FLAG_TIMER_STOP from the idling
> states because that flag actually doesn't have any negative effects,
> but still is correct for the case of a local CPU timer on older Tegra
> SoCs:
>
> cpuidle: tegra: Remove CPUIDLE_FLAG_TIMER_STOP from Tegra114/124 idle-state
> cpuidle: tegra: Remove CPUIDLE_FLAG_TIMER_STOP from all states
>
> - The "Add unified driver for NVIDIA Tegra SoCs" patch got more polish.
> Tegra30 and Terga114 states are now squashed into a single common C7
> state (following Parker TRM terminology, see 17.2.2.2 Power Management
> States), more comments added, etc minor changes.
It would be useful to switch the power state terminology to the one used
for later chips:
LP0 becomes SC7
LP1 becomes C1
LP2 becomes CC7
Meaning of these states is as follows
C is a core state:
C1 clock gating
C2 not defined
C3 not defined
C4 not defined
C5 not defined
C6 not defined for ARM cores
C7 power-gating
CC is a CPU cluster C state:
CC1 cluster clock gated
CC2 not defined
CC3 fmax@Vmin: not used prior to Tegra186
CC4: cluster retention: no longer supported
CC5: not defined
CC6: cluster power gating
CC7: cluster rail gating
SC is a System C state:
SC1: not defined
SC2: not defined
SC3: not defined
SC4: not defined
SC5: not defined
SC6: not defined
SC7: VDD_SOC off
Cheers,
Peter.