[PATCH v3 0/3] PCI: pciehp: Do not turn off slot if presence comes up after link

[Stuart Hayes]

In older PCIe specs, PDS (presence detect) would come up when the
"in-band" presence detect pin connected, and would be up before DLLLA
(link active).

In PCIe 4.0 (as an ECN) and in PCIe 5.0, there is a new bit to show if
in-band presence detection can be disabled for the slot, and another bit
that disables it--and a recommendation that it should be disabled if it
can be. In addition, certain OEMs disable in-band presence detection
without implementing these bits.

This means it is possible to get a "card present" interrupt after the
link is up and the driver is loaded.  This causes an erroneous removal
of the device driver, followed by an immediate re-probing.

This patch set defines these new bits, uses them to disable in-band
presence detection if it can be, waits for PDS to go up if in-band
presence detection is disabled, and adds a DMI table that will let us
know if we should assume in-band presence is disabled on a system.

The first two patches in this set come from a patch set that was
submitted but not accepted many months ago by Alexandru Gagniuc [1].
The first is unmodified, the second has the commit message and timeout 
modified.

[1] https://patchwork.kernel.org/cover/10909167/
    [v3,0/4] PCI: pciehp: Do not turn off slot if presence comes up after link

v2:
- modify loop in pcie_wait_for_presence to do..while

v3:
- remove unused variable declaration
- modify text of warning message

Alexandru Gagniuc (2):
  PCI: pciehp: Add support for disabling in-band presence
  PCI: pciehp: Wait for PDS if in-band presence is disabled

Stuart Hayes (1):
  PCI: pciehp: Add dmi table for in-band presence disabled

 drivers/pci/hotplug/pciehp.h     |  1 +
 drivers/pci/hotplug/pciehp_hpc.c | 45 +++++++++++++++++++++++++++++++-
 include/uapi/linux/pci_regs.h    |  2 ++
 3 files changed, 47 insertions(+), 1 deletion(-)

-- 
2.18.1