Re: [PATCH net-next] net: axienet: In kconfig add ARM64 as supported platform

[Michal Simek]

On 18. 10. 19 8:54, Radhey Shyam Pandey wrote:
> xilinx axi_emac driver is supported on ZynqMP UltraScale platform(ARM64).
> So enable it in kconfig. Basic sanity testing is done on zu+ mpsoc zcu102
> evaluation board.
> 
> Signed-off-by: Radhey Shyam Pandey <radhey.shyam.pandey@xxxxxxxxxx>
> ---
>  drivers/net/ethernet/xilinx/Kconfig | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/net/ethernet/xilinx/Kconfig b/drivers/net/ethernet/xilinx/Kconfig
> index 8d994ce..a616bdc 100644
> --- a/drivers/net/ethernet/xilinx/Kconfig
> +++ b/drivers/net/ethernet/xilinx/Kconfig
> @@ -6,7 +6,7 @@
>  config NET_VENDOR_XILINX
>  	bool "Xilinx devices"
>  	default y
> -	depends on PPC || PPC32 || MICROBLAZE || ARCH_ZYNQ || MIPS || X86 || ARM || COMPILE_TEST
> +	depends on PPC || PPC32 || MICROBLAZE || ARCH_ZYNQ || MIPS || X86 || ARM || ARM64 || COMPILE_TEST

You can remove ARCH_ZYNQ from this line because ARM is there already.


>  	---help---
>  	  If you have a network (Ethernet) card belonging to this class, say Y.
>  
> @@ -26,11 +26,11 @@ config XILINX_EMACLITE
>  
>  config XILINX_AXI_EMAC
>  	tristate "Xilinx 10/100/1000 AXI Ethernet support"
> -	depends on MICROBLAZE || X86 || ARM || COMPILE_TEST
> +	depends on MICROBLAZE || X86 || ARM || ARM64 || COMPILE_TEST
>  	select PHYLINK
>  	---help---
>  	  This driver supports the 10/100/1000 Ethernet from Xilinx for the
> -	  AXI bus interface used in Xilinx Virtex FPGAs.
> +	  AXI bus interface used in Xilinx Virtex FPGAs and Soc's.
>  
>  config XILINX_LL_TEMAC
>  	tristate "Xilinx LL TEMAC (LocalLink Tri-mode Ethernet MAC) driver"
> 

M