[RFC 6/6] dt-bindings: mmc: sdhci-msm: Add clk scaling dt parameters

[Ram Prakash Gupta]

Adding clk scaling dt parameters.

Signed-off-by: Ram Prakash Gupta <rampraka@xxxxxxxxxxxxxx>
---
 Documentation/devicetree/bindings/mmc/sdhci-msm.txt | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/Documentation/devicetree/bindings/mmc/sdhci-msm.txt b/Documentation/devicetree/bindings/mmc/sdhci-msm.txt
index da4edb1..afaf88d 100644
--- a/Documentation/devicetree/bindings/mmc/sdhci-msm.txt
+++ b/Documentation/devicetree/bindings/mmc/sdhci-msm.txt
@@ -39,6 +39,21 @@ Required properties:
 	"cal"	- reference clock for RCLK delay calibration (optional)
 	"sleep"	- sleep clock for RCLK delay calibration (optional)
 
+Optional properties:
+- devfreq,freq-table - specifies supported frequencies for clock scaling.
+	Clock scaling logic shall toggle between these frequencies based
+	on card load. In case the defined frequencies are over or below
+	the supported card frequencies, they will be overridden
+	during card init. In case this entry is not supplied,
+	the driver will construct one based on the card
+	supported max and min frequencies.
+	The frequencies must be ordered from lowest to highest.
+
+- scaling-lower-bus-speed-mode - Few hosts can support DDR52 mode at the
+	same lower system voltage corner as high-speed mode. In such
+	cases, it is always better to put it in DDR  mode which will
+	improve the performance without any power impact.
+
 Example:
 
 	sdhc_1: sdhci@f9824900 {
@@ -56,6 +71,10 @@ Example:
 
 		clocks = <&gcc GCC_SDCC1_APPS_CLK>, <&gcc GCC_SDCC1_AHB_CLK>;
 		clock-names = "core", "iface";
+
+		devfreq,freq-table = <50000000 200000000>;
+		scaling-lower-bus-speed-mode = "DDR52"
+
 	};
 
 	sdhc_2: sdhci@f98a4900 {
-- 
1.9.1