[PATCH 05/10] nvmem: imx-ocotp: reset error status on probe

[Srinivas Kandagatla]

From: Lucas Stach <l.stach@xxxxxxxxxxxxxx>

If software running before the OCOTP driver is loaded left the
controller with the error status pending, the driver will never
be able to complete the read timing setup. Reset the error status
on probe to make sure the controller is in usable state.

Signed-off-by: Lucas Stach <l.stach@xxxxxxxxxxxxxx>
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
---
 drivers/nvmem/imx-ocotp.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/nvmem/imx-ocotp.c b/drivers/nvmem/imx-ocotp.c
index dff2f3c357f5..fc40555ca4cd 100644
--- a/drivers/nvmem/imx-ocotp.c
+++ b/drivers/nvmem/imx-ocotp.c
@@ -521,6 +521,10 @@ static int imx_ocotp_probe(struct platform_device *pdev)
 	if (IS_ERR(priv->clk))
 		return PTR_ERR(priv->clk);
 
+	clk_prepare_enable(priv->clk);
+	imx_ocotp_clr_err_if_set(priv->base);
+	clk_disable_unprepare(priv->clk);
+
 	priv->params = of_device_get_match_data(&pdev->dev);
 	imx_ocotp_nvmem_config.size = 4 * priv->params->nregs;
 	imx_ocotp_nvmem_config.dev = dev;
-- 
2.21.0