[PATCH v7 14/19] PM / devfreq: tegra30: Don't enable already enabled consecutive interrupts

[Dmitry Osipenko]

Consecutive up/down interrupt-bit is set in the interrupt status register
only if that interrupt was previously enabled. Thus enabling the already
enabled interrupt doesn't do much for us.

Signed-off-by: Dmitry Osipenko <digetx@xxxxxxxxx>
---
 drivers/devfreq/tegra30-devfreq.c | 4 ----
 1 file changed, 4 deletions(-)

diff --git a/drivers/devfreq/tegra30-devfreq.c b/drivers/devfreq/tegra30-devfreq.c
index 9cbee82880ff..a9336cf4b37a 100644
--- a/drivers/devfreq/tegra30-devfreq.c
+++ b/drivers/devfreq/tegra30-devfreq.c
@@ -261,8 +261,6 @@ static void actmon_isr_device(struct tegra_devfreq *tegra,
 
 		if (dev->boost_freq >= tegra->max_freq)
 			dev->boost_freq = tegra->max_freq;
-		else
-			dev_ctrl |= ACTMON_DEV_CTRL_CONSECUTIVE_ABOVE_WMARK_EN;
 	} else if (intr_status & ACTMON_DEV_INTR_CONSECUTIVE_LOWER) {
 		/*
 		 * new_boost = old_boost * down_coef
@@ -275,8 +273,6 @@ static void actmon_isr_device(struct tegra_devfreq *tegra,
 
 		if (dev->boost_freq < (ACTMON_BOOST_FREQ_STEP >> 1))
 			dev->boost_freq = 0;
-		else
-			dev_ctrl |= ACTMON_DEV_CTRL_CONSECUTIVE_BELOW_WMARK_EN;
 	}
 
 	if (dev->config->avg_dependency_threshold) {
-- 
2.23.0