[PATCH 5.3 099/193] RDMA/mlx5: Clear old rate limit when closing QP

[Greg Kroah-Hartman]

From: Rafi Wiener <rafiw@xxxxxxxxxxxx>

[ Upstream commit c8973df2da677f375f8b12b6eefca2f44c8884d5 ]

Before QP is closed it changes to ERROR state, when this happens
the QP was left with old rate limit that was already removed from
the table.

Fixes: 7d29f349a4b9 ("IB/mlx5: Properly adjust rate limit on QP state transitions")
Signed-off-by: Rafi Wiener <rafiw@xxxxxxxxxxxx>
Signed-off-by: Oleg Kuporosov <olegk@xxxxxxxxxxxx>
Signed-off-by: Leon Romanovsky <leonro@xxxxxxxxxxxx>
Link: https://lore.kernel.org/r/20191002120243.16971-1-leon@xxxxxxxxxx
Signed-off-by: Doug Ledford <dledford@xxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
 drivers/infiniband/hw/mlx5/qp.c | 8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/drivers/infiniband/hw/mlx5/qp.c b/drivers/infiniband/hw/mlx5/qp.c
index 72869ff4a3342..3903141a387ed 100644
--- a/drivers/infiniband/hw/mlx5/qp.c
+++ b/drivers/infiniband/hw/mlx5/qp.c
@@ -3249,10 +3249,12 @@ static int modify_raw_packet_qp_sq(
 	}
 
 	/* Only remove the old rate after new rate was set */
-	if ((old_rl.rate &&
-	     !mlx5_rl_are_equal(&old_rl, &new_rl)) ||
-	    (new_state != MLX5_SQC_STATE_RDY))
+	if ((old_rl.rate && !mlx5_rl_are_equal(&old_rl, &new_rl)) ||
+	    (new_state != MLX5_SQC_STATE_RDY)) {
 		mlx5_rl_remove_rate(dev, &old_rl);
+		if (new_state != MLX5_SQC_STATE_RDY)
+			memset(&new_rl, 0, sizeof(new_rl));
+	}
 
 	ibqp->rl = new_rl;
 	sq->state = new_state;
-- 
2.20.1