Re: [PATCH v2 0/2] ARM: dts: ls1021a: define and use external interrupt lines

[Vladimir Oltean]

On Thu, 14 Nov 2019 at 23:40, David Miller <davem@xxxxxxxxxxxxx> wrote:
>
> From: Rasmus Villemoes <linux@xxxxxxxxxxxxxxxxxx>
> Date: Thu, 14 Nov 2019 12:02:51 +0100
>
> > A device tree binding documentation as well as a driver implementing
> > support for the external interrupt lines on the ls1021a has been
> > merged into irqchip-next, so will very likely appear in v5.5. See
> >
> > 87cd38dfd9e6 dt/bindings: Add bindings for Layerscape external irqs
> > 0dcd9f872769 irqchip: Add support for Layerscape external interrupt lines
> >
> > present in next-20191114.
> >
> > These patches simply add the extirq node to the ls1021a.dtsi and make
> > use of it on the LS1021A-TSN board. I hope these can be picked up so
> > they also land in v5.5, so we don't have to wait a full extra release
> > cycle.
> >
> > v2: fix interrupt type in 2/2 (s/IRQ_TYPE_EDGE_FALLING/IRQ_TYPE_LEVEL_LOW/).
>
> I am assuming this will go via an ARM tree.

Yes, of course, they are for Shawn. Netdev and Andrew was copied for
patch 2/2 (an SGMII PHY interrupt).

Regards,
-Vladimir