[PATCH v7 1/2] dt-bindings: edac: arm-dmc520.txt

[Shiping Ji]

This is the device tree bindings for new EDAC driver dmc520_edac.c.

Signed-off-by: Lei Wang <leiwang_git@xxxxxxxxxxx>
Reviewed-by: James Morse <james.morse@xxxxxxx>

---
     Changes in v7:
         - Added arm prefix to the interrupt-config property

---
 .../devicetree/bindings/edac/arm-dmc520.txt   | 26 +++++++++++++++++++
 1 file changed, 26 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/edac/arm-dmc520.txt

diff --git a/Documentation/devicetree/bindings/edac/arm-dmc520.txt b/Documentation/devicetree/bindings/edac/arm-dmc520.txt
new file mode 100644
index 000000000000..476cf8b76f2a
--- /dev/null
+++ b/Documentation/devicetree/bindings/edac/arm-dmc520.txt
@@ -0,0 +1,26 @@
+* ARM DMC-520 EDAC node
+
+Required properties:
+- compatible  : "brcm,dmc-520", "arm,dmc-520".
+- reg   : Address range of the DMC-520 registers.
+- interrupts  : DMC-520 interrupt numbers. The example below specifies
+     two interrupt lines for dram_ecc_errc_int and
+     dram_ecc_errd_int.
+- arm,interrupt-config : This is an array of interrupt masks. For each of the
+     above interrupt line, add one interrupt mask element to
+     it. That is, there is a 1:1 mapping from each interrupt
+     line to an interrupt mask. An interrupt mask can represent
+     multiple interrupts being enabled. Refer to interrupt_control
+     register in DMC-520 TRM for interrupt mapping. In the example
+     below, the interrupt configuration enables dram_ecc_errc_int
+     and dram_ecc_errd_int. And each interrupt is connected to
+     a separate interrupt line.
+
+Example:
+
+dmc0: dmc@200000 {
+ compatible = "brcm,dmc-520", "arm,dmc-520";
+ reg = <0x200000 0x80000>;
+ interrupts = <0x0 0x349 0x4>, <0x0 0x34B 0x4>;
+ arm,interrupt-config = <0x4>, <0x8>;
+};
-- 
2.17.1