[PATCH v1] msm:disp:dpu1: setup display datapath for SC7180 target

[Kalyan Thota]

SC7180 follows a newer architecture where in some flush controls have been re-organized to simplify programming and provide for future expandability. 
Specifically:
1) The TIMING_<j> bits that control flush of INTF_<j> have been replaced with a common INTF flush bit which flushes the programming in the MDP_CTL_<id>_INTF_ACTIVE register
2) Individual flush bits for MERGE_3D, DSC and CDWN have been added which flush the programming in the MDP_CTL_<id>_MERGE_3D_ACTIVE, ... etc respectively
3) PERIPH flush bit has been added to flush DSP packets for DisplayPort

The complete datapath is described using the MDP_CTL_<id>_TOP and newly added ACTIVE registers to handle other sub blocks
such as interface (INTF) resources, PingPong buffer / Layer Mixer, Display Stream Compression (DSC) resources, writeback (WB) and 3D Merge 
selections that are part of the datapath.



Kalyan Thota (1):
  msm:disp:dpu1: setup display datapath for SC7180 target

 drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c        |  4 +-
 .../gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c   | 21 +++++-
 drivers/gpu/drm/msm/disp/dpu1/dpu_hw_catalog.c     |  1 +
 drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.c         | 84 +++++++++++++++++++++-
 drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.h         | 24 +++++++
 drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c        | 28 ++++++++
 drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h        |  6 ++
 7 files changed, 161 insertions(+), 7 deletions(-)

-- 
1.9.1