Re: [PATCH v3 3/6] dt-bindings: mfd: da9062: add regulator voltage selection documentation

[Mark Brown]

On Fri, Nov 29, 2019 at 06:25:34PM +0100, Marco Felsch wrote:

> +  Optional regulator device-specific properties:
> +  - dlg,vsel-sense-gpios : A GPIO reference to a local general purpose input,
> +    the datasheet calls it GPI. The regulator sense the input signal and select
> +    the active or suspend voltage settings. If the signal is active the
> +    active-settings are applied else the suspend-settings are applied.
> +    Attention: Sharing the same GPI for other purposes or across multiple
> +    regulators is possible but the polarity setting must equal.

I'm really confused by this.  As far as I understand it it seems
to be doing pinmuxing on the chip using the GPIO bindings which
is itself a bit odd and I don't see anything here that configures
whatever sets the state of the pins.  Don't we need another GPIO
to set the vsel-sense inputs on the PMIC?

Attachment: signature.asc
Description: PGP signature