Re: [PATCH v10 2/3] PCI: dwc: intel: PCIe RC controller driver

From: Bjorn Helgaas
Date: Tue Dec 10 2019 - 18:50:31 EST


On Fri, Dec 06, 2019 at 03:27:49PM +0800, Dilip Kota wrote:
> Add support to PCIe RC controller on Intel Gateway SoCs.
> PCIe controller is based of Synopsys DesignWare PCIe core.
>
> Intel PCIe driver requires Upconfigure support, Fast Training
> Sequence and link speed configurations. So adding the respective
> helper functions in the PCIe DesignWare framework.
> It also programs hardware autonomous speed during speed
> configuration so defining it in pci_regs.h.
>
> Also, mark Intel PCIe driver depends on MSI IRQ Domain
> as Synopsys DesignWare framework depends on the
> PCI_MSI_IRQ_DOMAIN.
>
> Signed-off-by: Dilip Kota <eswara.kota@xxxxxxxxxxxxxxx>
> Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@xxxxxxx>
> Reviewed-by: Andrew Murray <andrew.murray@xxxxxxx>
> Reviewed-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxx>
> Acked-by: Gustavo Pimentel <gustavo.pimentel@xxxxxxxxxxxx>

> --- a/drivers/pci/controller/dwc/pcie-designware.c
> +++ b/drivers/pci/controller/dwc/pcie-designware.c
> @@ -14,6 +14,8 @@
>
> #include "pcie-designware.h"
>
> +extern const unsigned char pcie_link_speed[];

This shouldn't be needed; there's a declaration in drivers/pci/pci.h.

> +struct intel_pcie_soc {
> + unsigned int pcie_ver;
> + unsigned int pcie_atu_offset;
> + u32 num_viewport;
> +};

Looks a little strange to have the fields below lined up but the ones
above not.

> +struct intel_pcie_port {
> + struct dw_pcie pci;
> + void __iomem *app_base;
> + struct gpio_desc *reset_gpio;
> + u32 rst_intrvl;
> + u32 max_speed;
> + u32 link_gen;
> + u32 max_width;
> + u32 n_fts;
> + struct clk *core_clk;
> + struct reset_control *core_rst;
> + struct phy *phy;
> + u8 pcie_cap_ofst;
> +};
> +
> +static void pcie_update_bits(void __iomem *base, u32 ofs, u32 mask, u32 val)
> +{
> + u32 old;
> +
> + old = readl(base + ofs);
> + val = (old & ~mask) | (val & mask);
> +
> + if (val != old)
> + writel(val, base + ofs);

I assume this is never used on registers where the "old & ~mask" part
contains RW1C bits? If there are RW1C bits in that part, this will
corrupt them.

> + if (!lpp->pcie_cap_ofst) {
> + ret = dw_pcie_find_capability(&lpp->pci, PCI_CAP_ID_EXP);
> + if (!ret) {
> + ret = -ENXIO;
> + dev_err(dev, "Invalid PCIe capability offset\n");

Some of your messages start with a capital letter, others not.

> +int intel_pcie_msi_init(struct pcie_port *pp)

You might add a comment here like the one at
ks_pcie_am654_msi_host_init(). Since the users of the
.msi_host_init() function pointer only call the function if the
pointer is non-NULL, it's not completely obvious why you have this
stub function.

> +{
> + /* PCIe MSI/MSIx is handled by MSI in x86 processor */
> + return 0;
> +}

> + /*
> + * Intel PCIe doesn't configure IO region, so set viewport
> + * to not to perform IO region access.

s/to not to/to not/

> + */
> + pci->num_viewport = data->num_viewport;
> +
> + dev_info(dev, "Intel PCIe Root Complex Port init done\n");

Probably superfluous.

> +
> + return ret;

Since the return value is known here:

return 0;

> +}