Re: [PATCH] arm64: dts: ls1028a: put SAIs into async mode

[Shawn Guo]

On Fri, Nov 29, 2019 at 10:09:37PM +0100, Michael Walle wrote:
> The LS1028A SoC has only unidirectional SAIs. Therefore, it doesn't make
> sense to have the RX and TX part synchronous. Even worse, the RX part
> wont work out of the box because by default it is configured as
> synchronous to the TX part. And as said before, the pinmux of the SoC
> can only be configured to route either the RX or the TX signals to the
> SAI but never both at the same time. Thus configure the asynchronous
> mode by default.
> 
> Signed-off-by: Michael Walle <michael@xxxxxxxx>

Applied, thanks.