Re: [PATCH RFC 0/2] Add Renesas RPC-IF support

[Sergei Shtylyov]

HEllo

On 12/11/2019 05:33 PM, Chris Brandt wrote:

>> Here's a set of 2 patches against Linus' repo. Renesas Reduced Pin Count
>> Interface (RPC-IF) allows a SPI flash or HyperFlash connected to the SoC to
>> be accessed via the external address space read mode or the manual mode.
> 
> Looking at this driver, all it is are APIs. Meaning another driver is 
> needed to sit in between the MTD layer and this HW driver layer.

   Between the hardware and SPI, and between the hardware and HyperFlash
infrastructure. There's a lot of the common hardware code common between
these 2 driver areas.

> In the driver that I did, if the "RPC" HW is going to be used to control
> a SPI Flash device, it registered a spi controller and then the MTD 
> layer could access the device just like any other SPI controller driver. No
> additional drivers are needed.

   We're already been thru that with Mason's patch -- I don't want the code
duplicated between 2 drivers.

> Looking at the hyperbus driver that is in drivers/mtd/hyperbus/, it 
> seems that if the "RPC" HW is going to be used to control HyperFlash, then 

   Sure. But the code controlling RPC hardware is largely the same b/w 2 cases.

> all you would need to do is register a hyperbus controller using 
> hyperbus_register_device(). Then the MTD layer could read/write the flash using 
> normal MTD CFI interface.

   That's what I do (the current realization makes too many assumptions about
the HF hardware (both direct read and write). 

> Why do you think you need another layer in between the HW driver and the
> MTD layer?

   Because we don't want any duplicated code. Also, think about DT -- it
describes the hardware, not the driver configuration.

> Is your goal to make a multi-layered system where the HW jumps back and forth
> in between operating modes at runtime? I'm not sure of the use case for all of
> this.

   My goal is to prevent the code duplication (and keep DT sane too).

> Chris

MBR, Sergei